[Freedreno] [PATCH 4/4] drm/bridge: ti-sn65dsi86: Add NO_CONNECTOR support

[Laurent Pinchart]

Hi Rob and Doug,

On Mon, Sep 20, 2021 at 11:32:02AM -0700, Rob Clark wrote:
> On Thu, Aug 12, 2021 at 1:08 PM Doug Anderson wrote:
> > On Thu, Aug 12, 2021 at 12:26 PM Laurent Pinchart wrote:
> > > On Wed, Aug 11, 2021 at 04:52:50PM -0700, Rob Clark wrote:
> > > > From: Rob Clark <robdclark at chromium.org>
> > > >
> > > > Slightly awkward to fish out the display_info when we aren't creating
> > > > own connector.  But I don't see an obvious better way.
> > >
> > > We need a bit more than this, to support the NO_CONNECTOR case, the
> > > bridge has to implement a few extra operations, and set the bridge .ops
> > > field. I've submitted two patches to do so a while ago:
> > >
> > > - [RFC PATCH 08/11] drm/bridge: ti-sn65dsi86: Implement bridge connector operations ([1])
> >
> > Rob asked me about this over IRC, so if he left it out and it's needed
> > then it's my fault. However, I don't believe it's needed until your
> > series making this bridge chip support full DP. For the the eDP case
> > the bridge chip driver in ToT no longer queries the EDID itself. It
> > simply provides an AUX bus to the panel driver and the panel driver
> > queries the EDID. I think that means we don't need to add
> > DRM_BRIDGE_OP_EDID, right?

That's right.

> > I was also wondering if in the full DP case we should actually model
> > the physical DP jack as a drm_bridge and have it work the same way. It
> > would get probed via the DP AUX bus just like a panel. I seem to
> > remember Stephen Boyd was talking about modeling the DP connector as a
> > drm_bridge because it would allow us to handle the fact that some TCPC
> > chips could only support HBR2 whereas others could support HBR3. Maybe
> > it would end up being a fairly elegant solution?

Physical connectors are already handled as bridges, see
drivers/gpu/drm/bridge/display-connector.c. I however don't think it
should handle EDID retrieval, because that's really not an operation
implemented by the connector itself.

> > > - [RFC PATCH 09/11] drm/bridge: ti-sn65dsi86: Make connector creation optional ([2])
> > >
> > > The second patch is similar to the first half of this patch, but misses
> > > the cleanup code. I'll try to rebase this and resubmit, but it may take
> > > a bit of time.
> >
> > Whoops! You're right that Rob's patch won't work at all because we'll
> > just hit the "Fix bridge driver to make connector optional!" case. I
> > should have noticed that. :(
> 
> Yes, indeed.. once I fix that, I get no display..
> 
> Not sure if Laurent is still working on his series, otherwise I can
> try to figure out what bridge ops are missing

I am, but too slowly. I don't mind fast-tracking the changes you need
though.

-- 
Regards,

Laurent Pinchart