[Freedreno] [PATCH 12/23] drm/msm/mdp5: Remove redundant zpos initialisation

[Maxime Ripard]

The mdp KMS driver will call drm_plane_create_zpos_property() with an
init value depending on the plane purpose.

Since the initial value wasn't carried over in the state, the driver had
to set it again in mdp5_plane_reset(). However, the helpers have been
adjusted to set it properly at reset, so this is not needed anymore.

Cc: freedreno at lists.freedesktop.org
Cc: linux-arm-msm at vger.kernel.org
Cc: Abhinav Kumar <quic_abhinavk at quicinc.com>
Cc: Rob Clark <robdclark at gmail.com>
Cc: Sean Paul <sean at poorly.run>
Signed-off-by: Maxime Ripard <maxime at cerno.tech>
---
 drivers/gpu/drm/msm/disp/mdp5/mdp5_plane.c | 7 -------
 1 file changed, 7 deletions(-)

diff --git a/drivers/gpu/drm/msm/disp/mdp5/mdp5_plane.c b/drivers/gpu/drm/msm/disp/mdp5/mdp5_plane.c
index d60982f4bd11..5d8ac84c510b 100644
--- a/drivers/gpu/drm/msm/disp/mdp5/mdp5_plane.c
+++ b/drivers/gpu/drm/msm/disp/mdp5/mdp5_plane.c
@@ -98,13 +98,6 @@ static void mdp5_plane_reset(struct drm_plane *plane)
 
 	kfree(to_mdp5_plane_state(plane->state));
 	mdp5_state = kzalloc(sizeof(*mdp5_state), GFP_KERNEL);
-
-	if (plane->type == DRM_PLANE_TYPE_PRIMARY)
-		mdp5_state->base.zpos = STAGE_BASE;
-	else
-		mdp5_state->base.zpos = STAGE0 + drm_plane_index(plane);
-	mdp5_state->base.normalized_zpos = mdp5_state->base.zpos;
-
 	__drm_atomic_helper_plane_reset(plane, &mdp5_state->base);
 }
 
-- 
2.34.1