[Freedreno] [PATCH] drm/msm/dsi: Enable BURST_MODE for command mode for DSI 6G v1.3+

[Dmitry Baryshkov]

On 13/06/2023 02:37, Jessica Zhang wrote:
> During a frame transfer in command mode, there could be frequent
> LP11 <-> HS transitions when multiple DCS commands are sent mid-frame or
> if the DSI controller is running on slow clock and is throttled. To
> minimize frame latency due to these transitions, it is recommended to
> send the frame in a single burst.
> 
> This feature is supported for DSI 6G 1.3 and above, thus enable burst
> mode if supported.
> 
> Signed-off-by: Jessica Zhang <quic_jesszhan at quicinc.com>
> ---
>   drivers/gpu/drm/msm/dsi/dsi_host.c | 5 +++++
>   1 file changed, 5 insertions(+)
> 
> diff --git a/drivers/gpu/drm/msm/dsi/dsi_host.c b/drivers/gpu/drm/msm/dsi/dsi_host.c
> index 744f2398a6d6..8254b06dca85 100644
> --- a/drivers/gpu/drm/msm/dsi/dsi_host.c
> +++ b/drivers/gpu/drm/msm/dsi/dsi_host.c
> @@ -994,6 +994,11 @@ static void dsi_timing_setup(struct msm_dsi_host *msm_host, bool is_bonded_dsi)
>   		dsi_write(msm_host, REG_DSI_CMD_MDP_STREAM0_TOTAL,
>   			DSI_CMD_MDP_STREAM0_TOTAL_H_TOTAL(hdisplay) |
>   			DSI_CMD_MDP_STREAM0_TOTAL_V_TOTAL(mode->vdisplay));
> +
> +		if (msm_host->cfg_hnd->major == MSM_DSI_VER_MAJOR_6G &&
> +				msm_host->cfg_hnd->minor >= MSM_DSI_6G_VER_MINOR_V1_3)
> +			dsi_write(msm_host, REG_DSI_CMD_MODE_MDP_CTRL2,
> +					DSI_CMD_MODE_MDP_CTRL2_BURST_MODE);

Please move this to dsi_ctrl_config(), the place where we set all the 
configs. Also please change this to RMW cycle.

>   	}
>   }
>   
> 
> ---
> base-commit: dd969f852ba4c66938c71889e826aa8e5300d2f2
> change-id: 20230608-b4-add-burst-mode-a5bb144069fa
> 
> Best regards,

-- 
With best wishes
Dmitry