[Freedreno] [PATCH v1 1/2] drm/msm/dp: enable HDP plugin/unplugged interrupts to hpd_enable/disable

[Dmitry Baryshkov]

On Fri, 12 May 2023 at 21:03, Stephen Boyd <swboyd at chromium.org> wrote:
>
> Quoting Dmitry Baryshkov (2023-05-11 17:54:19)
> > On Fri, 12 May 2023 at 03:16, Kuogee Hsieh <quic_khsieh at quicinc.com> wrote:
> > > 1) DP with GPIO: No downstream drm_bridge are connected, is_edp = false
> > > and internal HPD-logic is in used (internal_hpd = true). Power needs to
> > > be on at all times etc.
> > >
> > > 2) DP without GPIO: Downstream drm_bridge connected, is_edp = false and
> > > internal HPD-logic should not be used/enabled (internal_hpd = false).
> > > Power doesn't need to be on unless hpd_notify is invoked to tell us that
> > > there's something connected...
> > >
> > > - dp_bridge_hpd_notify(). What is the point of this check? <== i have
> > > below two questions,
> > >
> > > 1) can you explain when/what this dp_bridge_hpd_notify() will be called?
> >
> > The call chain is drm_bridge_hpd_notify() ->
> > drm_bridge_connector_hpd_notify() -> .hpd_notify() for all drm_bridge
> > in chain
> >
> > One should add a call to drm_bridge_hpd_notify() when the hotplug
> > event has been detected.
> >
> > Also please note the patch https://patchwork.freedesktop.org/patch/484432/
> >
> > >
> > > 2) is dp_bridge_hpd_notify() only will be called at above case #2? and
> > > it will not be used by case #1?
> >
> > Once the driver calls drm_bridge_hpd_notify() in the hpd path, the
> > hpd_notify callbacks will be called in case#1 too.
> >
> > BTW: I don't see drm_bridge_hpd_notify() or
> > drm_kms_{,connector_}_hotplug_event() HPD notifications in the DP
> > driver at all. This should be fixed.
> >
>
> Is dp_bridge_hpd_notify() being called by
> drm_helper_probe_single_connector_modes() when the connectors are
> detected?
>
> I see drm_helper_probe_detect() calls connector->funcs->detect() which I
> think calls
> drm_bridge_connector_funcs::drm_bridge_connector_hpd_notify() but I
> haven't confirmed yet. The 'detect' bridge is the DP bridge in msm
> driver
>
>          if (!dp_display->is_edp) {
>                 bridge->ops =
>                         DRM_BRIDGE_OP_DETECT |
>
> so if the bridge_connector is being used then I think when fill_modes()
> is called we'll run the detect cycle and call the hpd_notify callbacks
> on the bridge chain.

Yes. This call chain is correct.
drm_helper_probe_single_connector_modes() ->
drm_bridge_connector_detect() -> drm_bridge_connector_hpd_notify().

However on HPD events the DP driver doesn't call into the drm core
(which I believe should be fixed).

-- 
With best wishes
Dmitry