[Freedreno] [PATCH v11 4/9] drm/msm/dsi: use DRM DSC helpers for DSC setup

[Marijn Suijten]

On 2023-05-17 11:51:13, Jessica Zhang wrote:
> From: Dmitry Baryshkov <dmitry.baryshkov at linaro.org>
> 
> Use new DRM DSC helpers to setup DSI DSC configuration. The
> initial_scale_value needs to be adjusted according to the standard, but
> this is a separate change.
> 
> Signed-off-by: Dmitry Baryshkov <dmitry.baryshkov at linaro.org>
> Reviewed-by: Abhinav Kumar <quic_abhinavk at quicinc.com>
> Signed-off-by: Jessica Zhang <quic_jesszhan at quicinc.com>

Nothing changed since v10 so it should have been finde to pick up my
r-b [1]?

Reviewed-by: Marijn Suijten <marijn.suijten at somainline.org>

[1]: https://lore.kernel.org/linux-arm-msm/6f3v5xmv66yw7mxecwqbrj6mxlfos3cwosb6xqs7hjbgrjgfqz@acm27l7qot5f/

- Marijn

> ---
>  drivers/gpu/drm/msm/dsi/dsi_host.c | 61 +++++---------------------------------
>  1 file changed, 8 insertions(+), 53 deletions(-)
> 
> diff --git a/drivers/gpu/drm/msm/dsi/dsi_host.c b/drivers/gpu/drm/msm/dsi/dsi_host.c
> index 961689a255c4..74d38f90398a 100644
> --- a/drivers/gpu/drm/msm/dsi/dsi_host.c
> +++ b/drivers/gpu/drm/msm/dsi/dsi_host.c
> @@ -1731,28 +1731,9 @@ static int dsi_host_parse_lane_data(struct msm_dsi_host *msm_host,
>  	return -EINVAL;
>  }
>  
> -static u32 dsi_dsc_rc_buf_thresh[DSC_NUM_BUF_RANGES - 1] = {
> -	0x0e, 0x1c, 0x2a, 0x38, 0x46, 0x54, 0x62,
> -	0x69, 0x70, 0x77, 0x79, 0x7b, 0x7d, 0x7e
> -};
> -
> -/* only 8bpc, 8bpp added */
> -static char min_qp[DSC_NUM_BUF_RANGES] = {
> -	0, 0, 1, 1, 3, 3, 3, 3, 3, 3, 5, 5, 5, 7, 13
> -};
> -
> -static char max_qp[DSC_NUM_BUF_RANGES] = {
> -	4, 4, 5, 6, 7, 7, 7, 8, 9, 10, 11, 12, 13, 13, 15
> -};
> -
> -static char bpg_offset[DSC_NUM_BUF_RANGES] = {
> -	2, 0, 0, -2, -4, -6, -8, -8, -8, -10, -10, -12, -12, -12, -12
> -};
> -
>  static int dsi_populate_dsc_params(struct msm_dsi_host *msm_host, struct drm_dsc_config *dsc)
>  {
> -	int i;
> -	u16 bpp = dsc->bits_per_pixel >> 4;
> +	int ret;
>  
>  	if (dsc->bits_per_pixel & 0xf) {
>  		DRM_DEV_ERROR(&msm_host->pdev->dev, "DSI does not support fractional bits_per_pixel\n");
> @@ -1764,49 +1745,23 @@ static int dsi_populate_dsc_params(struct msm_dsi_host *msm_host, struct drm_dsc
>  		return -EOPNOTSUPP;
>  	}
>  
> -	dsc->rc_model_size = 8192;
> -	dsc->first_line_bpg_offset = 12;
> -	dsc->rc_edge_factor = 6;
> -	dsc->rc_tgt_offset_high = 3;
> -	dsc->rc_tgt_offset_low = 3;
>  	dsc->simple_422 = 0;
>  	dsc->convert_rgb = 1;
>  	dsc->vbr_enable = 0;
>  
> -	/* handle only bpp = bpc = 8 */
> -	for (i = 0; i < DSC_NUM_BUF_RANGES - 1 ; i++)
> -		dsc->rc_buf_thresh[i] = dsi_dsc_rc_buf_thresh[i];
> +	drm_dsc_set_const_params(dsc);
> +	drm_dsc_set_rc_buf_thresh(dsc);
>  
> -	for (i = 0; i < DSC_NUM_BUF_RANGES; i++) {
> -		dsc->rc_range_params[i].range_min_qp = min_qp[i];
> -		dsc->rc_range_params[i].range_max_qp = max_qp[i];
> -		/*
> -		 * Range BPG Offset contains two's-complement signed values that fill
> -		 * 8 bits, yet the registers and DCS PPS field are only 6 bits wide.
> -		 */
> -		dsc->rc_range_params[i].range_bpg_offset = bpg_offset[i] & DSC_RANGE_BPG_OFFSET_MASK;
> +	/* handle only bpp = bpc = 8, pre-SCR panels */
> +	ret = drm_dsc_setup_rc_params(dsc, DRM_DSC_1_1_PRE_SCR);
> +	if (ret) {
> +		DRM_DEV_ERROR(&msm_host->pdev->dev, "could not find DSC RC parameters\n");
> +		return ret;
>  	}
>  
> -	dsc->initial_offset = 6144;		/* Not bpp 12 */
> -	if (bpp != 8)
> -		dsc->initial_offset = 2048;	/* bpp = 12 */
> -
> -	if (dsc->bits_per_component <= 10)
> -		dsc->mux_word_size = DSC_MUX_WORD_SIZE_8_10_BPC;
> -	else
> -		dsc->mux_word_size = DSC_MUX_WORD_SIZE_12_BPC;
> -
> -	dsc->initial_xmit_delay = 512;
>  	dsc->initial_scale_value = 32;
> -	dsc->first_line_bpg_offset = 12;
>  	dsc->line_buf_depth = dsc->bits_per_component + 1;
>  
> -	/* bpc 8 */
> -	dsc->flatness_min_qp = 3;
> -	dsc->flatness_max_qp = 12;
> -	dsc->rc_quant_incr_limit0 = 11;
> -	dsc->rc_quant_incr_limit1 = 11;
> -
>  	return drm_dsc_compute_rc_parameters(dsc);
>  }
>  
> 
> -- 
> 2.40.1
>