[PATCH v5 09/12] drm/msm/dpu: move rot90 checking to dpu_plane_atomic_check_pipe()

[Abhinav Kumar]

On 6/26/2024 2:46 PM, Dmitry Baryshkov wrote:
> Move a call to dpu_plane_check_inline_rotation() to the
> dpu_plane_atomic_check_pipe() function, so that the rot90 constraints
> are checked for both pipes. Also move rotation field from struct
> dpu_plane_state to struct dpu_sw_pipe_cfg.
> 
> Signed-off-by: Dmitry Baryshkov <dmitry.baryshkov at linaro.org>
> ---
>   drivers/gpu/drm/msm/disp/dpu1/dpu_hw_sspp.h |  2 ++
>   drivers/gpu/drm/msm/disp/dpu1/dpu_plane.c   | 55 +++++++++++++++--------------
>   drivers/gpu/drm/msm/disp/dpu1/dpu_plane.h   |  2 --
>   3 files changed, 31 insertions(+), 28 deletions(-)
> 

Change LGTM and addresses one of the questions I had in the prev patch.

One question though, till patch 11 which adds support for 2 different 
SSPPs for the plane this change is not necessary right? Because till 
that change we assign the same SSPP OR two rectangles of the same SSPP 
so we dont need a per pipe_cfg check till then because both the 
pipe_cfgs point to the same SSPP.

What is your thought on squashing this with patch 11 because from a 
logical split PoV, this change is meaningful only after that.