[PATCH 11/11] drm/bridge: anx7625: change the gpiod_set_value API

[Ayushi Makhija]

Use gpiod_set_value_cansleep() instead of gpiod_set_value()
to fix the below call trace in the boot log:

[    5.690534] Call trace:
[    5.690536]  gpiod_set_value+0x40/0xa4
[    5.690540]  anx7625_runtime_pm_resume+0xa0/0x324 [anx7625]
[    5.690545]  __rpm_callback+0x48/0x1d8
[    5.690549]  rpm_callback+0x6c/0x78

Certain GPIO controllers require access via message-based buses
such as I2C or SPI, which may cause the GPIOs to enter a sleep
state. Therefore, use the gpiod_set_value_cansleep().

Signed-off-by: Ayushi Makhija <quic_amakhija at quicinc.com>
---
 drivers/gpu/drm/bridge/analogix/anx7625.c | 8 ++++----
 1 file changed, 4 insertions(+), 4 deletions(-)

diff --git a/drivers/gpu/drm/bridge/analogix/anx7625.c b/drivers/gpu/drm/bridge/analogix/anx7625.c
index 9b6303267924..563944aa9012 100644
--- a/drivers/gpu/drm/bridge/analogix/anx7625.c
+++ b/drivers/gpu/drm/bridge/analogix/anx7625.c
@@ -1257,10 +1257,10 @@ static void anx7625_power_on(struct anx7625_data *ctx)
 	usleep_range(11000, 12000);
 
 	/* Power on pin enable */
-	gpiod_set_value(ctx->pdata.gpio_p_on, 1);
+	gpiod_set_value_cansleep(ctx->pdata.gpio_p_on, 1);
 	usleep_range(10000, 11000);
 	/* Power reset pin enable */
-	gpiod_set_value(ctx->pdata.gpio_reset, 1);
+	gpiod_set_value_cansleep(ctx->pdata.gpio_reset, 1);
 	usleep_range(10000, 11000);
 
 	DRM_DEV_DEBUG_DRIVER(dev, "power on !\n");
@@ -1280,9 +1280,9 @@ static void anx7625_power_standby(struct anx7625_data *ctx)
 		return;
 	}
 
-	gpiod_set_value(ctx->pdata.gpio_reset, 0);
+	gpiod_set_value_cansleep(ctx->pdata.gpio_reset, 0);
 	usleep_range(1000, 1100);
-	gpiod_set_value(ctx->pdata.gpio_p_on, 0);
+	gpiod_set_value_cansleep(ctx->pdata.gpio_p_on, 0);
 	usleep_range(1000, 1100);
 
 	ret = regulator_bulk_disable(ARRAY_SIZE(ctx->pdata.supplies),
-- 
2.34.1