[gst-devel] debugging in gstreamer

[Vinod Nanjaiah]

Hi Edward,
Thanks for the pointer.

I am running my code on N770 (ARM platform).
So, if I need to run refdbg tool on ARM, how can I go about doing that?

Regards,
Vinod



-----Original Message-----
From: Edward Hervey [mailto:bilboed at gmail.com] 
Sent: Wednesday, December 05, 2007 8:32 PM
To: Vinod Nanjaiah
Cc: gstreamer-devel at lists.sourceforge.net
Subject: Re: [gst-devel] debugging in gstreamer

Hi,

  This page should give you plenty of debugging hints for gstreamer and
gstreamer-based applications:

  http://www.buzztard.org/index.php/Debugging

    Edward

On Wed, 2007-12-05 at 20:14 +0530, Vinod Nanjaiah wrote:
> Hi!
> How can I find out memory leaks in gstreamer?
> I am explicitly not allocating memory anywhere in my code; only using
> gstreamer calls.
> 
> Regards,
> Vinod
> 


DISCLAIMER:
This message (including attachment if any) is confidential and may be privileged. If you have received this message by mistake please notify the sender by return e-mail and delete this message from your system. Any unauthorized use or dissemination of this message in whole or in part is strictly prohibited.
E-mail may contain viruses. Before opening attachments please check them for viruses and defects. While MindTree Consulting Limited (MindTree) has put in place checks to minimize the risks, MindTree will not be responsible for any viruses or defects or any forwarded attachments emanating either from within MindTree or outside.
Please note that e-mails are susceptible to change and MindTree shall not be liable for any improper, untimely or incomplete transmission.
MindTree reserves the right to monitor and review the content of all messages sent to or from MindTree e-mail address. Messages sent to or from this e-mail address may be stored on the MindTree e-mail system or else where.