[gst-devel] video on N770

[Vinod Nanjaiah]

Hi!
I am facing the following issues in video playback on N770.

1> After a few times of playback, video doesn't playback.

2> If the N770 screen is left untouched during video playback it goes into
power save mode (backlight completely off). After that video disappears.

The pipeline that I am using is 
filesrc ! queue ! demux d d.audio_00 ! queue ! mad (or wavparse) !
audioconvert ! dsppcmsink d.video_00 ! queue ! dspmpeg4sink 

What can be done to keep the screen alive during video playback?
And is there something that can be done to avoid the video playback
disappearing?

Regards,
Vinod


DISCLAIMER:
This message (including attachment if any) is confidential and may be privileged. If you have received this message by mistake please notify the sender by return e-mail and delete this message from your system. Any unauthorized use or dissemination of this message in whole or in part is strictly prohibited.
E-mail may contain viruses. Before opening attachments please check them for viruses and defects. While MindTree Consulting Limited (MindTree) has put in place checks to minimize the risks, MindTree will not be responsible for any viruses or defects or any forwarded attachments emanating either from within MindTree or outside.
Please note that e-mails are susceptible to change and MindTree shall not be liable for any improper, untimely or incomplete transmission.
MindTree reserves the right to monitor and review the content of all messages sent to or from MindTree e-mail address. Messages sent to or from this e-mail address may be stored on the MindTree e-mail system or else where.