[gst-devel] gstreamer not recognizing new plugin

[Nikhil Raveendranathan]

Hello all,

 

My gstreamer plugin is getting built fine on my host pc and scratchbox. In
both, I am able to use gst-inspect and gst-launch without any trouble. But
when I copy the same .so to N800, it is not getting recognized properly. In
fact I am getting this error:

 

GLIB WARNING ** GStreamer - Failed to load plugin: Opening module failed:
/usr/lib/gstreamer-0.10/libgstviddec.so: undefined symbol:
gst_type_register_static_full

 

Does anyone know why does this happen? What can I do about it?

 

Thanks and regards,

Nikhil

 



DISCLAIMER:
This message (including attachment if any) is confidential and may be privileged. If you have received this message by mistake please notify the sender by return e-mail and delete this message from your system. Any unauthorized use or dissemination of this message in whole or in part is strictly prohibited.
E-mail may contain viruses. Before opening attachments please check them for viruses and defects. While MindTree Consulting Limited (MindTree) has put in place checks to minimize the risks, MindTree will not be responsible for any viruses or defects or any forwarded attachments emanating either from within MindTree or outside.
Please note that e-mails are susceptible to change and MindTree shall not be liable for any improper, untimely or incomplete transmission.
MindTree reserves the right to monitor and review the content of all messages sent to or from MindTree e-mail address. Messages sent to or from this e-mail address may be stored on the MindTree e-mail system or else where.
-------------- next part --------------
An HTML attachment was scrubbed...
URL: <http://lists.freedesktop.org/archives/gstreamer-devel/attachments/20080124/8dea0858/attachment.htm>