[igt-dev] [PATCH i-g-t 2/2] tests/i915_pm_disag_freq: New test for media freq factor

[Kamil Konieczny]

Hi Ashutosh,

Dnia 2022-04-13 at 10:27:47 -0700, Ashutosh Dixit napisał(a):
> XEHPSDV and DG2/ATS-M allow media IP blocks to run at frequencies different
> from the GT frequency. i915 exposes sysfs controls for this frequency
> "disaggregation". IGT's introduced in this patch exercise and verify these
> per-gt (gt/gtN) sysfs attributes.
> 
> Further, RPS defaults exposed in gt/gtN/.defaults sysfs directory are used
> in the test to start and complete in the known default state.
> 
> Cc: Anshuman Gupta <anshuman.gupta at intel.com>
> Signed-off-by: Ashutosh Dixit <ashutosh.dixit at intel.com>
> ---
>  tests/i915/i915_pm_disag_freq.c | 182 ++++++++++++++++++++++++++++++++

imho test should be named i915_pm_media_freq.c

>  tests/meson.build               |   8 ++
>  2 files changed, 190 insertions(+)
>  create mode 100644 tests/i915/i915_pm_disag_freq.c
> 
> diff --git a/tests/i915/i915_pm_disag_freq.c b/tests/i915/i915_pm_disag_freq.c
> new file mode 100644
> index 000000000000..596ac9e8fd24
> --- /dev/null
> +++ b/tests/i915/i915_pm_disag_freq.c
> @@ -0,0 +1,182 @@
> +// SPDX-License-Identifier: MIT
> +/*
> + * Copyright © 2022 Intel Corporation
> + */
> +
> +#include <sys/types.h>
> +#include <sys/stat.h>
> +#include <fcntl.h>
> +
> +#include "i915/gem.h"
> +#include "igt.h"
> +#include "igt_sysfs.h"
> +
> +#define FREQ_SCALE_FACTOR	0.00390625f	/* 1.0f / 256 */
> +
> +/*
> + * Firmware interfaces are not completely synchronous, a delay is needed
> + * before the requested freq is actually set.
> + * Media ratio read back after set will mismatch if this value is too small
> + */
> +#define wait_freq_set()	usleep(100000)

Isn't it a little too big ? 10^5 is about 0.1s ?

> +
> +static int i915 = -1;
> +const intel_ctx_t *ctx;
> +uint64_t ahnd;
> +
> +static void spin_all(void)
> +{
> +	igt_spin_t *spin = igt_spin_new(i915, .ahnd = ahnd, .ctx = ctx, .engine = ALL_ENGINES,
> +					.flags = IGT_SPIN_POLL_RUN);
> +
> +	/* Wait till at least one spinner starts */
> +	igt_spin_busywait_until_started(spin);
> +}
> +
> +static void restore_rps_defaults(int dir)
> +{
> +	int def, min, max, media;
> +
> +	/* Read from gt/gtN/.defaults/ write to gt/gtN/ */
> +	def = openat(dir, ".defaults", O_RDONLY);
> +	if (def <= 0)
> +		return;
> +
> +	max = igt_sysfs_get_u32(def, "rps_max_freq_mhz");
> +	igt_sysfs_set_u32(dir, "rps_max_freq_mhz", max);
> +
> +	min = igt_sysfs_get_u32(def, "rps_min_freq_mhz");
> +	igt_sysfs_set_u32(dir, "rps_min_freq_mhz", min);
> +
> +	if (igt_sysfs_has_attr(dir, "media_freq_factor")) {
> +		media = igt_sysfs_get_u32(def, "media_freq_factor");
> +		igt_sysfs_set_u32(dir, "media_freq_factor", media);
> +	}
> +
> +	close(def);
> +}
> +
> +static void __restore_rps_defaults(int sig)
> +{
> +	int dir, gt;
> +
> +	for_each_sysfs_gt_dirfd(i915, dir, gt)
> +		restore_rps_defaults(dir);
> +}
> +
> +static void setup_freq(int gt, int dir)
> +{
> +	int rp0, rp1, rpn, min, max, act, media;
> +
> +	ctx = intel_ctx_create_all_physical(i915);
> +	ahnd = get_reloc_ahnd(i915, ctx->id);
> +
> +	/* Reset to known state */
> +	restore_rps_defaults(dir);
> +
> +	/* Spin on all engines to jack freq up to max */
> +	spin_all();
> +	wait_freq_set();
> +
> +	/* Print some debug information */
> +	rp0 = igt_sysfs_get_u32(dir, "rps_RP0_freq_mhz");
> +	rp1 = igt_sysfs_get_u32(dir, "rps_RP1_freq_mhz");
> +	rpn = igt_sysfs_get_u32(dir, "rps_RPn_freq_mhz");
> +	min = igt_sysfs_get_u32(dir, "rps_min_freq_mhz");
> +	max = igt_sysfs_get_u32(dir, "rps_max_freq_mhz");
> +	act = igt_sysfs_get_u32(dir, "rps_act_freq_mhz");
> +
> +	igt_info("RP0 mhz: %d, RP1 mhz: %d, RPn mhz: %d, min mhz: %d, max mhz: %d, act mhz: %d\n", rp0, rp1, rpn, min, max, act);
> +
> +	if (igt_sysfs_has_attr(dir, "media_freq_factor")) {
> +		media = igt_sysfs_get_u32(dir, "media_freq_factor");
> +		igt_info("media ratio: %.2f\n", media * FREQ_SCALE_FACTOR);
> +	}
> +}
> +
> +static void cleanup(int dir)
> +{
> +	igt_free_spins(i915);
> +	put_ahnd(ahnd);
> +	intel_ctx_destroy(i915, ctx);
> +	restore_rps_defaults(dir);
> +	gem_quiescent_gpu(i915);
> +}
> +
> +static void media_freq(int gt, int dir)
> +{
> +	float scale;
> +
> +	igt_require(igt_sysfs_has_attr(dir, "media_freq_factor"));
> +
> +	igt_sysfs_scanf(dir, "media_freq_factor.scale", "%g", &scale);
> +	igt_assert_eq(scale, FREQ_SCALE_FACTOR);
> +
> +	setup_freq(gt, dir);
> +
> +	igt_info("media RP0 mhz: %d, media RPn mhz: %d\n",
> +		 igt_sysfs_get_u32(dir, "media_RP0_freq_mhz"),
> +		 igt_sysfs_get_u32(dir, "media_RPn_freq_mhz"));
> +	igt_info("media ratio value 0.0 represents dynamic mode\n");
> +
> +	/*
> +	 * Media freq ratio modes supported are: dynamic (0), 1:2 (128) and
> +	 * 1:1 (256). Setting dynamic (0) can return any of the three
> +	 * modes. Fixed ratio modes should return the same value.
> +	 */
> +	for (int v = 256; v >= 0; v -= 64) {
> +		int getv, ret;
> +
> +		/*
> +		 * Check that we can set the mode. Ratios other than 1:2
> +		 * and 1:1 are not supported.
> +		 */
> +		ret = igt_sysfs_printf(dir, "media_freq_factor", "%u", v);
> +		if (ret <= 0) {
> +			igt_info("Media ratio %.2f is not supported\n", v * scale);
> +			continue;
> +		}
> +
> +		wait_freq_set();
> +
> +		getv = igt_sysfs_get_u32(dir, "media_freq_factor");
> +
> +		igt_info("media ratio set: %.2f, media ratio get: %.2f\n",
> +			 v * scale, getv * scale);
> +
> +		/*
> +		 * Skip validation in dynamic mode since the returned media
> +		 * ratio and freq are platform dependent and not clearly defined
> +		 */
> +		if (!v)
> +			continue;
----------------------- ^

This is last iteration, so maybe just "break;" here or
		if (v)
			igt_assert_eq(getv, v);
		
If you change then also change comment appropriatly.

Do we need all that igt_info above ? I would change all or
almost all of them into igt_debug.

> +
> +		igt_assert_eq(getv, v);
> +	}
> +
> +	cleanup(dir);
> +}
> +
> +igt_main
> +{
> +	int dir, gt;
> +
> +	igt_fixture {
> +		i915 = drm_open_driver(DRIVER_INTEL);
> +
> +		/* Disag multipliers (aka "frequency factors") are not simulated. */
> +		igt_require(!igt_run_in_simulation());
> +		igt_install_exit_handler(__restore_rps_defaults);
> +	}
> +

Please put description before subtest, check with --describe
what needs to be described. Write also global description at
begin of file.

> +	igt_subtest_with_dynamic("media-freq") {
> +		for_each_sysfs_gt_dirfd(i915, dir, gt) {
> +			igt_dynamic_f("gt%d", gt)
> +				media_freq(gt, dir);
> +		}
> +	}
> +
> +	igt_fixture {
> +		close(i915);
> +	}
> +}
> diff --git a/tests/meson.build b/tests/meson.build
> index 7261e9aa2950..cd89defbb418 100644
> --- a/tests/meson.build
> +++ b/tests/meson.build
> @@ -356,6 +356,14 @@ test_executables += executable('gem_mmap_offset',
>  	   install : true)
>  test_list += 'gem_mmap_offset'
>  
> +test_executables += executable('i915_pm_disag_freq',
> +	   join_paths('i915', 'i915_pm_disag_freq.c'),
> +	   dependencies : test_deps + [ lib_igt_perf ],
> +	   install_dir : libexecdir,
> +	   install_rpath : libexecdir_rpathdir,
> +	   install : true)
> +test_list += 'i915_pm_disag_freq'
> +
>  test_executables += executable('i915_pm_rc6_residency',
>  	   join_paths('i915', 'i915_pm_rc6_residency.c'),
>  	   dependencies : test_deps + [ lib_igt_perf ],
> -- 
> 2.34.1
> 
Regards,
Kamil