[igt-dev] [i-g-t 24/51] tests/kms_plane_cursor: Add support for Bigjoiner

[Bhanuprakash Modem]

This patch will add a check to Skip the subtest if a selected pipe/output
combo won't support Bigjoiner or 8K mode.

Example:
* Pipe-D wont support a mode > 5K
* To use 8K mode on a pipe then consecutive pipe must be available & free.

Signed-off-by: Bhanuprakash Modem <bhanuprakash.modem at intel.com>
---
 tests/kms_plane_cursor.c | 8 ++++++--
 1 file changed, 6 insertions(+), 2 deletions(-)

diff --git a/tests/kms_plane_cursor.c b/tests/kms_plane_cursor.c
index 73085cc8..ab246508 100644
--- a/tests/kms_plane_cursor.c
+++ b/tests/kms_plane_cursor.c
@@ -76,12 +76,16 @@ static void test_init(data_t *data, enum pipe pipe_id)
 	data->overlay = igt_pipe_get_plane_type(data->pipe, DRM_PLANE_TYPE_OVERLAY);
 	data->cursor = igt_pipe_get_plane_type(data->pipe, DRM_PLANE_TYPE_CURSOR);
 
+	igt_output_set_pipe(data->output, data->pipe_id);
+	igt_require(igt_test_constraint(display));
+
+	igt_info("Using (pipe %s + %s) to run the subtest.\n",
+		 kmstest_pipe_name(data->pipe_id), igt_output_name(data->output));
+
 	igt_require_pipe_crc(data->drm_fd);
 	data->pipe_crc = igt_pipe_crc_new(data->drm_fd, data->pipe_id,
 					  INTEL_PIPE_CRC_SOURCE_AUTO);
 
-	igt_output_set_pipe(data->output, data->pipe_id);
-
 	/* Overlay rectangle for a rect in the center of the screen */
 	data->or.x = data->mode->hdisplay / 4;
 	data->or.y = data->mode->vdisplay / 4;
-- 
2.35.1