[igt-dev] [i-g-t 2/3] tests/kms_vrr: Add Negative tests to validate VRR

[Bhanuprakash Modem]

This patch will verify:

* VRR on Non-VRR panel:
	VRR should not be enabled on the Non-VRR panel.
	Hence Kernel should reject the commit.
* Monitor Refresh Rate range:
	Both vrr_min & vrr_max must be zero for Non-VRR panel.

Cc: Manasi Navare <manasi.d.navare at intel.com>
Signed-off-by: Bhanuprakash Modem <bhanuprakash.modem at intel.com>
---
 tests/kms_vrr.c | 76 +++++++++++++++++++++++++++++++++++++++++++++++--
 1 file changed, 74 insertions(+), 2 deletions(-)

diff --git a/tests/kms_vrr.c b/tests/kms_vrr.c
index 8976d4a6c3..4d75823d7e 100644
--- a/tests/kms_vrr.c
+++ b/tests/kms_vrr.c
@@ -45,6 +45,7 @@ enum {
 	TEST_DPMS = 1 << 0,
 	TEST_SUSPEND = 1 << 1,
 	TEST_FLIPLINE = 1 << 2,
+	TEST_NEGATIVE = 1 << 3,
 };
 
 typedef struct range {
@@ -244,6 +245,41 @@ static void prepare_test(data_t *data, igt_output_t *output, enum pipe pipe)
 	igt_display_commit2(&data->display, COMMIT_ATOMIC);
 }
 
+static void prepare_negative_test(data_t *data, igt_output_t *output, enum pipe pipe)
+{
+	drmModeModeInfo *mode;
+
+	/* Reset output */
+	igt_display_reset(&data->display);
+	igt_output_set_pipe(output, pipe);
+
+	/* Capture VRR range */
+	data->range = get_vrr_range(data, output);
+
+	/* As we are running Negative test on non-vrr panel, both vrr
+	 * min & max should be zero.
+	 */
+	igt_assert_eq(data->range.min, 0);
+	igt_assert_eq(data->range.max, 0);
+	mode = igt_output_get_mode(output);
+
+	/* Prepare resources */
+	igt_assert(igt_create_fb(data->drm_fd, mode->hdisplay, mode->vdisplay,
+				 DRM_FORMAT_XRGB8888, DRM_FORMAT_MOD_LINEAR,
+				 &data->fb0));
+
+	/* Take care of any required modesetting before the test begins. */
+	data->primary = igt_output_get_plane_type(output, DRM_PLANE_TYPE_PRIMARY);
+	igt_plane_set_fb(data->primary, &data->fb0);
+
+	/* Clear vrr_enabled state before enabling it, because
+	 * it might be left enabled if the previous test fails.
+	 */
+	igt_pipe_set_prop_value(&data->display, pipe, IGT_CRTC_VRR_ENABLED, 0);
+
+	igt_display_commit2(&data->display, COMMIT_ATOMIC);
+}
+
 /* Performs an atomic non-blocking page-flip on a pipe. */
 static void
 do_flip(data_t *data, igt_fb_t *fb)
@@ -430,6 +466,32 @@ test_basic(data_t *data, enum pipe pipe, igt_output_t *output, uint32_t flags)
 	igt_remove_fb(data->drm_fd, &data->fb0);
 }
 
+/* VRR on Non-VRR panel: VRR should not be enabled on the Non-VRR panel.
+ * Kernel should reject the commit.
+ */
+static void
+test_negative_basic(data_t *data, enum pipe pipe,
+		    igt_output_t *output, uint32_t flags)
+{
+	int ret;
+
+	igt_info("VRR Negative Test execution on %s, PIPE_%s.\n",
+			output->name, kmstest_pipe_name(pipe));
+
+	prepare_negative_test(data, output, pipe);
+	igt_pipe_set_prop_value(&data->display, pipe, IGT_CRTC_VRR_ENABLED, 1);
+
+	ret = igt_display_try_commit2(&data->display, COMMIT_ATOMIC);
+	igt_assert_f(ret == 0, "VRR shouln't be enabled on Non-VRR panel.\n");
+
+	/* Clean-up */
+	igt_plane_set_fb(data->primary, NULL);
+	igt_output_set_pipe(output, PIPE_NONE);
+	set_vrr_on_pipe(data, pipe, false);
+
+	igt_remove_fb(data->drm_fd, &data->fb0);
+}
+
 /* Runs tests on outputs that are VRR capable. */
 static void
 run_vrr_test(data_t *data, test_t test, uint32_t flags)
@@ -439,8 +501,14 @@ run_vrr_test(data_t *data, test_t test, uint32_t flags)
 	for_each_connected_output(&data->display, output) {
 		enum pipe pipe;
 
-		if (!has_vrr(output))
-			continue;
+		/* For Negative tests, panel should be non-vrr. */
+		if (flags & TEST_NEGATIVE) {
+			if (has_vrr(output))
+				continue;
+		} else {
+			if (!has_vrr(output))
+				continue;
+		}
 
 		for_each_pipe(&data->display, pipe) {
 			if (igt_pipe_connector_valid(pipe, output)) {
@@ -486,6 +554,10 @@ igt_main
 	igt_subtest_with_dynamic("flipline")
 		run_vrr_test(&data, test_basic, TEST_FLIPLINE);
 
+	igt_describe("Make sure that VRR should not be enabled on the Non-VRR panel.");
+	igt_subtest_with_dynamic("negative-basic")
+		run_vrr_test(&data, test_negative_basic, TEST_NEGATIVE);
+
 	igt_fixture {
 		igt_display_fini(&data.display);
 	}
-- 
2.35.0