[igt-dev] [i-g-t V3 26/52] tests/kms_plane_multiple: Add support for Bigjoiner

[Karthik B S]

On 9/9/2022 7:33 PM, Bhanuprakash Modem wrote:
> This patch will add a check to Skip the subtest if a selected pipe/output
> combo won't support Bigjoiner or 8K mode.
>
> Example:
> * Pipe-D wont support a mode > 5K
> * To use 8K mode on a pipe then consecutive pipe must be available & free.
>
> V2: - Use updated helper name
>
> Signed-off-by: Bhanuprakash Modem <bhanuprakash.modem at intel.com>
Reviewed-by: Karthik B S <karthik.b.s at intel.com>
> ---
>   tests/kms_plane_multiple.c | 15 ++++++++++++---
>   1 file changed, 12 insertions(+), 3 deletions(-)
>
> diff --git a/tests/kms_plane_multiple.c b/tests/kms_plane_multiple.c
> index cbe8c189..4ab49624 100644
> --- a/tests/kms_plane_multiple.c
> +++ b/tests/kms_plane_multiple.c
> @@ -102,6 +102,7 @@ get_reference_crc(data_t *data, igt_output_t *output, enum pipe pipe,
>   	igt_plane_t *primary;
>   	int ret;
>   
> +	igt_display_reset(&data->display);
>   	igt_output_set_pipe(output, pipe);
>   
>   	primary = igt_output_get_plane_type(output, DRM_PLANE_TYPE_PRIMARY);
> @@ -289,6 +290,9 @@ test_plane_position_with_output(data_t *data, enum pipe pipe,
>   	bool loop_forever;
>   	char info[256];
>   
> +	igt_info("Using (pipe %s + %s) to run the subtest.\n",
> +		 kmstest_pipe_name(pipe), igt_output_name(output));
> +
>   	if (opt.iterations == LOOP_FOREVER) {
>   		loop_forever = true;
>   		sprintf(info, "forever");
> @@ -374,12 +378,17 @@ static void run_test(data_t *data, uint64_t modifier)
>   {
>   	enum pipe pipe;
>   	igt_output_t *output;
> +	igt_display_t *display = &data->display;
>   
> -	if (!igt_display_has_format_mod(&data->display, DRM_FORMAT_XRGB8888, modifier))
> +	if (!igt_display_has_format_mod(display, DRM_FORMAT_XRGB8888, modifier))
>   		return;
>   
> -	for_each_pipe_with_valid_output(&data->display, pipe, output) {
> -		igt_display_reset(&data->display);
> +	for_each_pipe_with_valid_output(display, pipe, output) {
> +		igt_display_reset(display);
> +
> +		igt_output_set_pipe(output, pipe);
> +		if (!i915_pipe_output_combo_valid(display))
> +			continue;
>   
>   		igt_dynamic_f("pipe-%s-%s", kmstest_pipe_name(pipe), output->name)
>   			test_plane_position(data, pipe, output, modifier);