[Bug 81951] gma500_gfx: "No Signal" to monitor on boot

[bugzilla-daemon at bugzilla.kernel.org]

https://bugzilla.kernel.org/show_bug.cgi?id=81951

Alan <alan at lxorguk.ukuu.org.uk> changed:

           What    |Removed                     |Added
----------------------------------------------------------------------------
                 CC|                            |alan at lxorguk.ukuu.org.uk

--- Comment #1 from Alan <alan at lxorguk.ukuu.org.uk> ---
Unfortunately for a board and BIOS ACPI setting specific bug like that you'd
pretty much need someone in front of the board to debug it. Poulsbo uses an
Imagination graphics core so there is no documentation and the driver is built
out of bits that were required to be released under the GPL, and a lot of
trial/error and guesswork.

If there is some kind of bridge or external logic that has magic power hooks
not in the code that it was developed from then you are basically out of luck

-- 
You are receiving this mail because:
You are on the CC list for the bug.