<html>
    <head>
      <base href="https://bugs.freedesktop.org/">
    </head>
    <body>
      <p>
        <div>
            <b><a class="bz_bug_link 
          bz_status_ASSIGNED "
   title="ASSIGNED - [GLK] no signal after switch resolution from 1080p@23.98"
   href="https://bugs.freedesktop.org/show_bug.cgi?id=105887#c68">Comment # 68</a>
              on <a class="bz_bug_link 
          bz_status_ASSIGNED "
   title="ASSIGNED - [GLK] no signal after switch resolution from 1080p@23.98"
   href="https://bugs.freedesktop.org/show_bug.cgi?id=105887">bug 105887</a>
              from <span class="vcard"><a class="email" href="mailto:clinton.a.taylor@intel.com" title="Clinton Taylor <clinton.a.taylor@intel.com>"> <span class="fn">Clinton Taylor</span></a>
</span></b>
        <pre>After bashing my head against he wall for several days I have finally
determined that the issue is caused by the HDMI level shifter on the board and
not a driver issue. 

After changing the mode from 1080p24 to 1080p50 the scope shows a valid clock
into the level shifter and a very low amplitude clock on the output to the
connector. Adding a short delay after the Transcoder is disabled appears to
solve the issue with the level shifter.

I have attached a scope shot of the waveform into the level shifter (yellow
trace) and the output to the connector (blue trace).</pre>
        </div>
      </p>


      <hr>
      <span>You are receiving this mail because:</span>

      <ul>
          <li>You are on the CC list for the bug.</li>
          <li>You are the QA Contact for the bug.</li>
      </ul>
    </body>
</html>