<html> <head> <base href="https://bugs.freedesktop.org/"> </head> <body> <div> <a class="bz_bug_link bz_status_NEW " title="NEW - [CI] igt@kms_ccs@pipe-[a|b]-crc-sprite-planes-basic - fail - Test assertion failure function try_config, Failed assertion: ret == 0" href="https://bugs.freedesktop.org/show_bug.cgi?id=105458#c5">Comment # 5</a> on <a class="bz_bug_link bz_status_NEW " title="NEW - [CI] igt@kms_ccs@pipe-[a|b]-crc-sprite-planes-basic - fail - Test assertion failure function try_config, Failed assertion: ret == 0" href="https://bugs.freedesktop.org/show_bug.cgi?id=105458">bug 105458</a> from <a class="email" href="mailto:juhapekka.heikkila@gmail.com" title="Juha-Pekka Heikkilä <juhapekka.heikkila@gmail.com>"> Juha-Pekka Heikkilä</a> <pre>This test is hitting the limits of hw. At the point of failure screen resolutions are quite high (for example 2400x1600) dmesg gets such messages as <7>[ 906.448757] [drm:skl_compute_wm_levels [i915]] Requested display configuration exceeds system watermark limitations <7>[ 906.448920] [drm:skl_compute_wm_levels [i915]] [PLANE:33:plane 2A] blocks required = 33/32, lines required = 8/31 I can make this test to pass by disabling display WA #1126 but then I'm be working against the spec and mis-adjusting watermarks for level 0 could show up in wrong ways in some other use case. I'll make this test to skip if setup phase fails.</pre> </div> <hr> You are receiving this mail because: <ul> <li>You are the QA Contact for the bug.</li> <li>You are on the CC list for the bug.</li> </ul> </body> </html>