<html> <head> <base href="https://bugs.freedesktop.org/"> </head> <body> <div> <a class="bz_bug_link bz_status_NEEDINFO " title="NEEDINFO - Properties neither applied nor reset after monitor hotplug" href="https://bugs.freedesktop.org/show_bug.cgi?id=112340#c4">Comment # 4</a> on <a class="bz_bug_link bz_status_NEEDINFO " title="NEEDINFO - Properties neither applied nor reset after monitor hotplug" href="https://bugs.freedesktop.org/show_bug.cgi?id=112340">bug 112340</a> from <a class="email" href="mailto:Simon.Richter@hogyros.de" title="Simon Richter <Simon.Richter@hogyros.de>"> Simon Richter</a> <pre>Hm, it seems that this only happens when coming out of standby while the receiver is off, when the receiver is turned on afterwards. The kernel log has the following events: - Boot [0 - 24] - X startup [36 - 39] - disabling the internal LVDS display [57 - 62] - setting quantization range from Automatic to Full [72 - 73] - turning the receiver off and on [81 - 114] - forcing DPMS off and on [272 - 288] - forcing DPMS off, turning off the receiver, forcing DPMS on and turning on the receiver [306 - 366] The error manifests in the last case only, i.e. when the display comes out of standby while the receiver is still off. There seems to be a lot happening after the receiver is turned on, which kind of explains why it often takes several seconds until I can get a picture, especially the first time I cycled the receiver the whole experiment took thirty seconds until I had a stable picture again.</pre> </div> <hr> You are receiving this mail because: <ul> <li>You are on the CC list for the bug.</li> <li>You are the QA Contact for the bug.</li> <li>You are the assignee for the bug.</li> </ul> </body> </html>