[PATCH v1 2/2] drm/i915: Force state->modeset=true when distrust_bios_wm==true

[Stanislav Lisovskiy]

From: Ville Syrjälä <ville.syrjala at linux.intel.com>

Currently when we load the driver we set distrust_bios_wm=true, which
will cause active_pipe_changes to get flagged even when we're not
toggling any pipes on/off. The reason being that we want to fully
redistribute the dbuf among the active pipes and ignore whatever
state the firmware left behind.

Unfortunately when the code flags active_pipe_changes it doesn't
set state->modeset to true, which means the hardware dbuf state
won't actually get updated. Hence the hardware and software
states go out of sync, which can result in planes trying to use a
disabled dbuf slice. Suprisingly that only seems to corrupt the
display rather than making the whole display engine keel over.

Let's fix this for now by flagging state->modeset whenever
distrust_bios_wm is set.

Eventually we'll likely want to rip out all of this mess and
introduce proper statye tracking for dbuf. But that requires
more work. Toss in a FIXME to that effect.

Cc: Stanislav Lisovskiy <stanislav.lisovskiy at intel.com>
Fixes: ff2cd8635e41 ("drm/i915: Correctly map DBUF slices to pipes")
Signed-off-by: Ville Syrjälä <ville.syrjala at linux.intel.com>
Reviewed-by: Stanislav Lisovskiy <stanislav.lisovskiy at intel.com>
---
 drivers/gpu/drm/i915/display/intel_display.c | 14 ++++++++++++++
 1 file changed, 14 insertions(+)

diff --git a/drivers/gpu/drm/i915/display/intel_display.c b/drivers/gpu/drm/i915/display/intel_display.c
index 61ba1f2256a0..9e4f99ae81fb 100644
--- a/drivers/gpu/drm/i915/display/intel_display.c
+++ b/drivers/gpu/drm/i915/display/intel_display.c
@@ -15027,6 +15027,20 @@ static int intel_atomic_check(struct drm_device *dev,
 	if (new_cdclk_state && new_cdclk_state->force_min_cdclk_changed)
 		any_ms = true;
 
+	/*
+	 * distrust_bios_wm will force a full dbuf recomputation
+	 * but the hardware state will only get updated accordingly
+	 * if state->modeset==true. Hence distrust_bios_wm==true &&
+	 * state->modeset==false is an invalid combination which
+	 * would cause the hardware and software dbuf state to get
+	 * out of sync. We must prevent that.
+	 *
+	 * FIXME clean up this mess and introduce better
+	 * state tracking for dbuf.
+	 */
+	if (dev_priv->wm.distrust_bios_wm)
+		any_ms = true;
+
 	if (any_ms) {
 		ret = intel_modeset_checks(state);
 		if (ret)
-- 
2.24.1.485.gad05a3d8e5