[PATCH 3/3] drm/i915/display: Call panel_fitting from pipe_config

[Nemesa Garg]

In panel fitter/pipe scaler scenario the pch_pfit configuration
currently takes place before accounting for pipe_src width for
joiner. This causes issue when pch_pfit and joiner get enabled
together. Call panel_fitting from pipe_config once pipe src is
computed.

v4: Remove need_joiner flag [Ville]

Signed-off-by: Nemesa Garg <nemesa.garg at intel.com>
---
 drivers/gpu/drm/i915/display/intel_display.c | 17 +++++++++++++++++
 1 file changed, 17 insertions(+)

diff --git a/drivers/gpu/drm/i915/display/intel_display.c b/drivers/gpu/drm/i915/display/intel_display.c
index b4ef4d59da1a..b16607b49303 100644
--- a/drivers/gpu/drm/i915/display/intel_display.c
+++ b/drivers/gpu/drm/i915/display/intel_display.c
@@ -4653,6 +4653,8 @@ intel_modeset_pipe_config(struct intel_atomic_state *state,
 		intel_atomic_get_new_crtc_state(state, crtc);
 	struct drm_connector *connector;
 	struct drm_connector_state *connector_state;
+	const struct drm_display_mode *fixed_mode;
+	struct intel_dp *intel_dp;
 	int pipe_src_w, pipe_src_h;
 	int base_bpp, ret, i;
 
@@ -4774,6 +4776,21 @@ intel_modeset_pipe_config(struct intel_atomic_state *state,
 		return ret;
 	}
 
+	for_each_new_connector_in_state(&state->base, connector,
+			connector_state, i) {
+		struct intel_encoder *encoder =
+			to_intel_encoder(connector_state->best_encoder);
+
+		if (connector_state->crtc != &crtc->base)
+			continue;
+
+		intel_dp = enc_to_intel_dp(encoder);
+
+		if ((intel_dp_is_edp(intel_dp) && fixed_mode) ||
+				crtc_state->output_format == INTEL_OUTPUT_FORMAT_YCBCR420)
+			return intel_pch_panel_fitting(crtc_state, connector_state);
+	}
+
 	/* Dithering seems to not pass-through bits correctly when it should, so
 	 * only enable it on 6bpc panels and when its not a compliance
 	 * test requesting 6bpc video pattern.
-- 
2.25.1