[Intel-gfx] [PATCH 09/21] drm/i915: Delay DP i2c initialization until panel power timings are computed
Keith Packard
keithp at keithp.com
Fri Sep 30 03:09:41 CEST 2011
On eDP, DDC requires panel power, but turning that on uses the panel
power sequencing timing values fetch from the DPCD data.
Signed-off-by: Keith Packard <keithp at keithp.com>
---
drivers/gpu/drm/i915/intel_dp.c | 4 ++--
1 files changed, 2 insertions(+), 2 deletions(-)
diff --git a/drivers/gpu/drm/i915/intel_dp.c b/drivers/gpu/drm/i915/intel_dp.c
index b915fc3..0b462f9 100644
--- a/drivers/gpu/drm/i915/intel_dp.c
+++ b/drivers/gpu/drm/i915/intel_dp.c
@@ -2069,8 +2069,6 @@ intel_dp_init(struct drm_device *dev, int output_reg)
break;
}
- intel_dp_i2c_init(intel_dp, intel_connector, name);
-
/* Cache some DPCD data in the eDP case */
if (is_edp(intel_dp)) {
bool ret;
@@ -2102,6 +2100,8 @@ intel_dp_init(struct drm_device *dev, int output_reg)
}
}
+ intel_dp_i2c_init(intel_dp, intel_connector, name);
+
intel_encoder->hot_plug = intel_dp_hot_plug;
if (is_edp(intel_dp)) {
--
1.7.6.3
More information about the Intel-gfx
mailing list