[Intel-gfx] [PATCH v5 3/4] drm/i915: Haswell HDMI audio enable

[Wang Xingchao]

Initialize Haswell HDMI audio registers to generate an unsolicited
response to the audio controller driver to indicate that the controller
sequence should start.

Signed-off-by: Wang Xingchao <xingchao.wang at intel.com>
---
 drivers/gpu/drm/i915/intel_display.c |   37 ++++++++++++++++++++++++++++++++++
 1 file changed, 37 insertions(+)

diff --git a/drivers/gpu/drm/i915/intel_display.c b/drivers/gpu/drm/i915/intel_display.c
index 17020cd..b635bf6 100644
--- a/drivers/gpu/drm/i915/intel_display.c
+++ b/drivers/gpu/drm/i915/intel_display.c
@@ -5071,6 +5071,7 @@ static void ironlake_write_eld(struct drm_connector *connector,
 				     struct drm_crtc *crtc)
 {
 	struct drm_i915_private *dev_priv = connector->dev->dev_private;
+	struct drm_device *dev = crtc->dev;
 	uint8_t *eld = connector->eld;
 	uint32_t eldv;
 	uint32_t i;
@@ -5079,12 +5080,18 @@ static void ironlake_write_eld(struct drm_connector *connector,
 	int aud_config;
 	int aud_cntl_st;
 	int aud_cntrl_st2;
+	int pipe = to_intel_crtc(crtc)->pipe;
 
 	if (HAS_PCH_IBX(connector->dev)) {
 		hdmiw_hdmiedid = IBX_HDMIW_HDMIEDID_A;
 		aud_config = IBX_AUD_CONFIG_A;
 		aud_cntl_st = IBX_AUD_CNTL_ST_A;
 		aud_cntrl_st2 = IBX_AUD_CNTL_ST2;
+	} else if (IS_HASWELL(dev)) {
+		hdmiw_hdmiedid = HSW_AUD_EDID_DATA(pipe);
+		aud_cntl_st = HSW_AUD_DIP_ELD_CTRL(pipe);
+		aud_config = HSW_AUD_CFG(pipe);
+		aud_cntrl_st2 = HSW_AUD_PIN_ELD_CP_VLD;
 	} else {
 		hdmiw_hdmiedid = CPT_HDMIW_HDMIEDID_A;
 		aud_config = CPT_AUD_CONFIG_A;
@@ -5092,6 +5099,34 @@ static void ironlake_write_eld(struct drm_connector *connector,
 		aud_cntrl_st2 = CPT_AUD_CNTRL_ST2;
 	}
 
+	if (IS_HASWELL(dev)) {
+		int tmp;
+		int aud_vld = HSW_AUD_PIN_ELD_CP_VLD;
+
+		DRM_DEBUG_DRIVER("HDMI: Haswell Audio initialize....\n");
+
+		/* Audio output enable */
+		DRM_DEBUG_DRIVER("HDMI audio: enable codec\n");
+		tmp = I915_READ(aud_vld);
+		tmp |= (AUDIO_OUTPUT_ENABLE_A | AUDIO_OUTPUT_ENABLE_B | AUDIO_OUTPUT_ENABLE_C);
+		I915_WRITE(aud_vld, tmp);
+
+		/* Set ELD valid state */
+		tmp = I915_READ(aud_vld);
+		DRM_DEBUG_DRIVER("HDMI audio: pin eld vld status=0x%8x\n", tmp);
+		tmp |= (AUDIO_ELD_VALID_A | AUDIO_ELD_VALID_B | AUDIO_ELD_VALID_C);
+		I915_WRITE(aud_vld, tmp);
+		tmp = I915_READ(aud_vld);
+		DRM_DEBUG_DRIVER("HDMI audio: eld vld status=0x%8x\n", tmp);
+
+		/* Enable HDMI mode */
+		tmp = I915_READ(aud_config);
+		DRM_DEBUG_DRIVER("HDMI audio: audio conf: 0x%8x\n", tmp);
+		/* clear N_programing_enable and N_value_index */
+		tmp &= ~(AUD_CONFIG_N_VALUE_INDEX | AUD_CONFIG_N_PROG_ENABLE);
+		I915_WRITE(aud_config, tmp);
+	}
+
 	i = to_intel_crtc(crtc)->pipe;
 	hdmiw_hdmiedid += i * 0x100;
 	aud_cntl_st += i * 0x100;
@@ -5135,6 +5170,8 @@ static void ironlake_write_eld(struct drm_connector *connector,
 	i = I915_READ(aud_cntl_st);
 	i &= ~IBX_ELD_ADDRESS;
 	I915_WRITE(aud_cntl_st, i);
+	i = (i >> 29) & 0x3;		/* DIP_Port_Select, 0x1 = PortB */
+	DRM_DEBUG_DRIVER("port num:%d\n", i);
 
 	len = min_t(uint8_t, eld[2], 21);	/* 84 bytes of hw ELD buffer */
 	DRM_DEBUG_DRIVER("ELD size %d\n", len);
-- 
1.7.9.5