[Intel-gfx] [PATCH v8 3/4] drm/i915: Haswell HDMI audio initialization
Wang, Xingchao
xingchao.wang at intel.com
Thu Aug 16 08:30:53 CEST 2012
Hi Daniel/Imre,
Changelog for v8:
- enabled proper output port based on current pipe
This version patch works well on my sharkbay machine.
This revised version changelog (v7):
- add " Wait for 1 vertical blank" after enable audio output port
- configure pipe related transcoder instead of operate all transcoders blindly
Thanks
--xingchao
> -----Original Message-----
> From: Wang, Xingchao
> Sent: Thursday, August 16, 2012 2:15 PM
> To: imre.deak at gmail.com; daniel at ffwll.ch
> Cc: intel-gfx at lists.freedesktop.org; Wang, Xingchao
> Subject: [PATCH v8 3/4] drm/i915: Haswell HDMI audio initialization
>
> Added new haswell_write_eld() to initialize Haswell HDMI audio registers to
> generate an unsolicited response to the audio controller driver to indicate that
> the controller sequence should start.
>
> Signed-off-by: Wang Xingchao <xingchao.wang at intel.com>
> ---
> drivers/gpu/drm/i915/i915_reg.h | 1 +
> drivers/gpu/drm/i915/intel_display.c | 98
> +++++++++++++++++++++++++++++++++-
> 2 files changed, 98 insertions(+), 1 deletion(-)
>
> diff --git a/drivers/gpu/drm/i915/i915_reg.h
> b/drivers/gpu/drm/i915/i915_reg.h index 55aa10e..08f8b65 100644
> --- a/drivers/gpu/drm/i915/i915_reg.h
> +++ b/drivers/gpu/drm/i915/i915_reg.h
> @@ -4294,6 +4294,7 @@
> #define AUD_DIG_CNVT(pipe) _PIPE(pipe, \
> HSW_AUD_DIG_CNVT_1, \
> HSW_AUD_DIG_CNVT_2)
> +#define DIP_PORT_SEL_MASK 0x3
>
> #define HSW_AUD_EDID_DATA_A 0x65050
> #define HSW_AUD_EDID_DATA_B 0x65150
> diff --git a/drivers/gpu/drm/i915/intel_display.c
> b/drivers/gpu/drm/i915/intel_display.c
> index 70d30fc..3b70777 100644
> --- a/drivers/gpu/drm/i915/intel_display.c
> +++ b/drivers/gpu/drm/i915/intel_display.c
> @@ -5067,6 +5067,102 @@ static void g4x_write_eld(struct drm_connector
> *connector,
> I915_WRITE(G4X_AUD_CNTL_ST, i);
> }
>
> +static void haswell_write_eld(struct drm_connector *connector,
> + struct drm_crtc *crtc)
> +{
> + struct drm_i915_private *dev_priv = connector->dev->dev_private;
> + uint8_t *eld = connector->eld;
> + struct drm_device *dev = crtc->dev;
> + uint32_t eldv;
> + uint32_t i;
> + int len;
> + int pipe = to_intel_crtc(crtc)->pipe;
> + int tmp;
> +
> + int hdmiw_hdmiedid = HSW_AUD_EDID_DATA(pipe);
> + int aud_cntl_st = HSW_AUD_DIP_ELD_CTRL(pipe);
> + int aud_config = HSW_AUD_CFG(pipe);
> + int aud_cntrl_st2 = HSW_AUD_PIN_ELD_CP_VLD;
> +
> +
> + DRM_DEBUG_DRIVER("HDMI: Haswell Audio initialize....\n");
> +
> + /* Audio output enable */
> + DRM_DEBUG_DRIVER("HDMI audio: enable codec\n");
> + tmp = I915_READ(aud_cntrl_st2);
> + tmp |= (AUDIO_OUTPUT_ENABLE_A << (pipe * 4));
> + I915_WRITE(aud_cntrl_st2, tmp);
> +
> + /* Wait for 1 vertical blank */
> + intel_wait_for_vblank(dev, pipe);
> +
> + /* Set ELD valid state */
> + tmp = I915_READ(aud_cntrl_st2);
> + DRM_DEBUG_DRIVER("HDMI audio: pin eld vld status=0x%8x\n", tmp);
> + tmp |= (AUDIO_ELD_VALID_A << (pipe * 4));
> + I915_WRITE(aud_cntrl_st2, tmp);
> + tmp = I915_READ(aud_cntrl_st2);
> + DRM_DEBUG_DRIVER("HDMI audio: eld vld status=0x%8x\n", tmp);
> +
> + /* Enable HDMI mode */
> + tmp = I915_READ(aud_config);
> + DRM_DEBUG_DRIVER("HDMI audio: audio conf: 0x%8x\n", tmp);
> + /* clear N_programing_enable and N_value_index */
> + tmp &= ~(AUD_CONFIG_N_VALUE_INDEX |
> AUD_CONFIG_N_PROG_ENABLE);
> + I915_WRITE(aud_config, tmp);
> +
> + DRM_DEBUG_DRIVER("ELD on pipe %c\n", pipe_name(pipe));
> +
> + i = I915_READ(aud_cntl_st);
> + i = (i >> 29) & DIP_PORT_SEL_MASK; /* DIP_Port_Select, 0x1 =
> PortB */
> + if (!i) {
> + DRM_DEBUG_DRIVER("Audio directed to unknown port\n");
> + /* operate blindly on all ports */
> + eldv = AUDIO_ELD_VALID_A;
> + eldv |= AUDIO_ELD_VALID_B;
> + eldv |= AUDIO_ELD_VALID_C;
> + } else {
> + DRM_DEBUG_DRIVER("ELD on port %c\n", 'A' + i);
> + eldv = AUDIO_ELD_VALID_A << ((i - 1) * 4);
> + }
> +
> + if (intel_pipe_has_type(crtc, INTEL_OUTPUT_DISPLAYPORT)) {
> + DRM_DEBUG_DRIVER("ELD: DisplayPort detected\n");
> + eld[5] |= (1 << 2); /* Conn_Type, 0x1 = DisplayPort */
> + I915_WRITE(aud_config, AUD_CONFIG_N_VALUE_INDEX); /* 0x1 =
> DP */
> + } else
> + I915_WRITE(aud_config, 0);
> +
> + if (intel_eld_uptodate(connector,
> + aud_cntrl_st2, eldv,
> + aud_cntl_st, IBX_ELD_ADDRESS,
> + hdmiw_hdmiedid))
> + return;
> +
> + i = I915_READ(aud_cntrl_st2);
> + i &= ~eldv;
> + I915_WRITE(aud_cntrl_st2, i);
> +
> + if (!eld[0])
> + return;
> +
> + i = I915_READ(aud_cntl_st);
> + i &= ~IBX_ELD_ADDRESS;
> + I915_WRITE(aud_cntl_st, i);
> + i = (i >> 29) & DIP_PORT_SEL_MASK; /* DIP_Port_Select, 0x1 =
> PortB */
> + DRM_DEBUG_DRIVER("port num:%d\n", i);
> +
> + len = min_t(uint8_t, eld[2], 21); /* 84 bytes of hw ELD buffer */
> + DRM_DEBUG_DRIVER("ELD size %d\n", len);
> + for (i = 0; i < len; i++)
> + I915_WRITE(hdmiw_hdmiedid, *((uint32_t *)eld + i));
> +
> + i = I915_READ(aud_cntrl_st2);
> + i |= eldv;
> + I915_WRITE(aud_cntrl_st2, i);
> +
> +}
> +
> static void ironlake_write_eld(struct drm_connector *connector,
> struct drm_crtc *crtc)
> {
> @@ -7041,7 +7137,7 @@ static void intel_init_display(struct drm_device
> *dev)
> dev_priv->display.write_eld = ironlake_write_eld;
> } else if (IS_HASWELL(dev)) {
> dev_priv->display.fdi_link_train = hsw_fdi_link_train;
> - dev_priv->display.write_eld = ironlake_write_eld;
> + dev_priv->display.write_eld = haswell_write_eld;
> } else
> dev_priv->display.update_wm = NULL;
> } else if (IS_G4X(dev)) {
> --
> 1.7.9.5
More information about the Intel-gfx
mailing list