[Intel-gfx] [PATCH] drm/i915: Preserve that FDI line reversal override bit on CPT

[Damien Lespiau]

From: Damien Lespiau <damien.lespiau at intel.com>

The FDI link has supported link reversal to make the PCB layout
engineer's life easier for quite a while and we have always presered
this bit as we programmed FDI_RX_CTL with a read/modify/write sequence.

We're trying to take a bit more control over what the BIOS leaves in
various register and with the introduction of DDI, started to program
FDI_RX_CTL fully.

There's a fused bit to indicate DMI link reversal and FDI defaults to
mirroring that configuration. We have a bit to override that behaviour
that we need to preserve from the BIOS.

Signed-off-by: Damien Lespiau <damien.lespiau at intel.com>
---
 drivers/gpu/drm/i915/i915_drv.h  |  2 +-
 drivers/gpu/drm/i915/i915_reg.h  |  2 +-
 drivers/gpu/drm/i915/intel_crt.c | 14 +++++++++-----
 drivers/gpu/drm/i915/intel_ddi.c |  6 ++----
 4 files changed, 13 insertions(+), 11 deletions(-)

diff --git a/drivers/gpu/drm/i915/i915_drv.h b/drivers/gpu/drm/i915/i915_drv.h
index 557843d..31fc37a 100644
--- a/drivers/gpu/drm/i915/i915_drv.h
+++ b/drivers/gpu/drm/i915/i915_drv.h
@@ -915,7 +915,7 @@ typedef struct drm_i915_private {
 	bool hw_contexts_disabled;
 	uint32_t hw_context_size;
 
-	bool fdi_rx_polarity_reversed;
+	u32 fdi_rx_config;
 
 	struct i915_suspend_saved_registers regfile;
 
diff --git a/drivers/gpu/drm/i915/i915_reg.h b/drivers/gpu/drm/i915/i915_reg.h
index 3f75cfa..ceeac97 100644
--- a/drivers/gpu/drm/i915/i915_reg.h
+++ b/drivers/gpu/drm/i915/i915_reg.h
@@ -3922,7 +3922,7 @@
 #define  FDI_10BPC                      (1<<16)
 #define  FDI_6BPC                       (2<<16)
 #define  FDI_12BPC                      (3<<16)
-#define  FDI_LINK_REVERSE_OVERWRITE     (1<<15)
+#define  FDI_RX_LINK_REVERSAL_OVERRIDE  (1<<15)
 #define  FDI_DMI_LINK_REVERSE_MASK      (1<<14)
 #define  FDI_RX_PLL_ENABLE              (1<<13)
 #define  FDI_FS_ERR_CORRECT_ENABLE      (1<<11)
diff --git a/drivers/gpu/drm/i915/intel_crt.c b/drivers/gpu/drm/i915/intel_crt.c
index fe20bf7..86b557e 100644
--- a/drivers/gpu/drm/i915/intel_crt.c
+++ b/drivers/gpu/drm/i915/intel_crt.c
@@ -800,10 +800,14 @@ void intel_crt_init(struct drm_device *dev)
 	dev_priv->hotplug_supported_mask |= CRT_HOTPLUG_INT_STATUS;
 
 	/*
-	 * TODO: find a proper way to discover whether we need to set the
-	 * polarity reversal bit or not, instead of relying on the BIOS.
+	 * TODO: find a proper way to discover whether we need to set the the
+	 * polarity and link reversal bits or not, instead of relying on the
+	 * BIOS.
 	 */
-	if (HAS_PCH_LPT(dev))
-		dev_priv->fdi_rx_polarity_reversed =
-		     !!(I915_READ(_FDI_RXA_CTL) & FDI_RX_POLARITY_REVERSED_LPT);
+	if (HAS_PCH_LPT(dev)) {
+		u32 fdi_config = FDI_RX_POLARITY_REVERSED_LPT |
+				 FDI_RX_LINK_REVERSAL_OVERRIDE;
+
+		dev_priv->fdi_rx_config = I915_READ(_FDI_RXA_CTL) & fdi_config;
+	}
 }
diff --git a/drivers/gpu/drm/i915/intel_ddi.c b/drivers/gpu/drm/i915/intel_ddi.c
index 4bad0f7..cb2dcc6 100644
--- a/drivers/gpu/drm/i915/intel_ddi.c
+++ b/drivers/gpu/drm/i915/intel_ddi.c
@@ -178,10 +178,8 @@ void hsw_fdi_link_train(struct drm_crtc *crtc)
 				  FDI_RX_TP1_TO_TP2_48 | FDI_RX_FDI_DELAY_90);
 
 	/* Enable the PCH Receiver FDI PLL */
-	rx_ctl_val = FDI_RX_PLL_ENABLE | FDI_RX_ENHANCE_FRAME_ENABLE |
-		     ((intel_crtc->fdi_lanes - 1) << 19);
-	if (dev_priv->fdi_rx_polarity_reversed)
-		rx_ctl_val |= FDI_RX_POLARITY_REVERSED_LPT;
+	rx_ctl_val = dev_priv->fdi_rx_config | FDI_RX_ENHANCE_FRAME_ENABLE |
+		     FDI_RX_PLL_ENABLE | ((intel_crtc->fdi_lanes - 1) << 19);
 	I915_WRITE(_FDI_RXA_CTL, rx_ctl_val);
 	POSTING_READ(_FDI_RXA_CTL);
 	udelay(220);
-- 
1.7.11.7