[Intel-gfx] [PATCH 72/76] drm/i915: clean up the cpu edp pll special case
Daniel Vetter
daniel.vetter at ffwll.ch
Thu Jul 26 20:49:37 CEST 2012
By using the new pre_enabel/post_disable functions.
To ensure that we only frob the cpu edp pll while the pipe is off add
the relevant asserts. Thanks to the new output state staging, this is
now really easy.
Signed-Off-by: Daniel Vetter <daniel.vetter at ffwll.ch>
---
drivers/gpu/drm/i915/intel_dp.c | 74 ++++++++++++++-------------------------
1 file changed, 27 insertions(+), 47 deletions(-)
diff --git a/drivers/gpu/drm/i915/intel_dp.c b/drivers/gpu/drm/i915/intel_dp.c
index df77929..0b92654 100644
--- a/drivers/gpu/drm/i915/intel_dp.c
+++ b/drivers/gpu/drm/i915/intel_dp.c
@@ -808,9 +808,6 @@ intel_dp_set_m_n(struct drm_crtc *crtc, struct drm_display_mode *mode,
}
}
-static void ironlake_edp_pll_on(struct drm_encoder *encoder);
-static void ironlake_edp_pll_off(struct drm_encoder *encoder);
-
static void
intel_dp_mode_set(struct drm_encoder *encoder, struct drm_display_mode *mode,
struct drm_display_mode *adjusted_mode)
@@ -821,14 +818,6 @@ intel_dp_mode_set(struct drm_encoder *encoder, struct drm_display_mode *mode,
struct drm_crtc *crtc = intel_dp->base.base.crtc;
struct intel_crtc *intel_crtc = to_intel_crtc(crtc);
- /* Turn on the eDP PLL if needed */
- if (is_edp(intel_dp)) {
- if (!is_pch_edp(intel_dp))
- ironlake_edp_pll_on(encoder);
- else
- ironlake_edp_pll_off(encoder);
- }
-
/*
* There are four kinds of DP registers:
*
@@ -1189,12 +1178,16 @@ static void ironlake_edp_backlight_off(struct intel_dp *intel_dp)
msleep(intel_dp->backlight_off_delay);
}
-static void ironlake_edp_pll_on(struct drm_encoder *encoder)
+static void ironlake_edp_pll_on(struct intel_dp *intel_dp)
{
- struct drm_device *dev = encoder->dev;
+ struct drm_device *dev = intel_dp->base.base.dev;
+ struct drm_crtc *crtc = intel_dp->base.base.crtc;
struct drm_i915_private *dev_priv = dev->dev_private;
u32 dpa_ctl;
+ assert_pipe_disabled(dev_priv,
+ to_intel_crtc(crtc)->pipe);
+
DRM_DEBUG_KMS("\n");
dpa_ctl = I915_READ(DP_A);
dpa_ctl |= DP_PLL_ENABLE;
@@ -1203,12 +1196,16 @@ static void ironlake_edp_pll_on(struct drm_encoder *encoder)
udelay(200);
}
-static void ironlake_edp_pll_off(struct drm_encoder *encoder)
+static void ironlake_edp_pll_off(struct intel_dp *intel_dp)
{
- struct drm_device *dev = encoder->dev;
+ struct drm_device *dev = intel_dp->base.base.dev;
+ struct drm_crtc *crtc = intel_dp->base.base.crtc;
struct drm_i915_private *dev_priv = dev->dev_private;
u32 dpa_ctl;
+ assert_pipe_disabled(dev_priv,
+ to_intel_crtc(crtc)->pipe);
+
dpa_ctl = I915_READ(DP_A);
dpa_ctl &= ~DP_PLL_ENABLE;
I915_WRITE(DP_A, dpa_ctl);
@@ -1309,6 +1306,14 @@ static void intel_disable_dp(struct intel_encoder *encoder)
ironlake_edp_panel_vdd_off(intel_dp, false);
}
+static void intel_post_disable_dp(struct intel_encoder *encoder)
+{
+ struct intel_dp *intel_dp = enc_to_intel_dp(&encoder->base);
+
+ if (is_cpu_edp(intel_dp))
+ ironlake_edp_pll_off(intel_dp);
+}
+
static void intel_enable_dp(struct intel_encoder *encoder)
{
struct intel_dp *intel_dp = enc_to_intel_dp(&encoder->base);
@@ -1328,39 +1333,12 @@ static void intel_enable_dp(struct intel_encoder *encoder)
ironlake_edp_backlight_on(intel_dp);
}
-static void
-intel_dp_dpms(struct drm_connector *connector, int mode)
+static void intel_pre_enable_dp(struct intel_encoder *encoder)
{
- struct intel_dp *intel_dp = intel_attached_dp(connector);
-
- /* DP supports only 2 dpms states. */
- if (mode != DRM_MODE_DPMS_ON)
- mode = DRM_MODE_DPMS_OFF;
-
- if (mode == connector->dpms)
- return;
-
- connector->dpms = mode;
-
- /* Only need to change hw state when actually enabled */
- if (!intel_dp->base.base.crtc) {
- intel_dp->base.connectors_active = false;
- return;
- }
-
- if (mode != DRM_MODE_DPMS_ON) {
- intel_encoder_dpms(&intel_dp->base, mode);
-
- if (is_cpu_edp(intel_dp))
- ironlake_edp_pll_off(&intel_dp->base.base);
- } else {
- if (is_cpu_edp(intel_dp))
- ironlake_edp_pll_on(&intel_dp->base.base);
-
- intel_encoder_dpms(&intel_dp->base, mode);
- }
+ struct intel_dp *intel_dp = enc_to_intel_dp(&encoder->base);
- intel_connector_check_state(to_intel_connector(connector));
+ if (is_cpu_edp(intel_dp))
+ ironlake_edp_pll_on(intel_dp);
}
/*
@@ -2395,7 +2373,7 @@ static const struct drm_encoder_helper_funcs intel_dp_helper_funcs = {
};
static const struct drm_connector_funcs intel_dp_connector_funcs = {
- .dpms = intel_dp_dpms,
+ .dpms = intel_connector_dpms,
.detect = intel_dp_detect,
.fill_modes = drm_helper_probe_single_connector_modes,
.set_property = intel_dp_set_property,
@@ -2526,7 +2504,9 @@ intel_dp_init(struct drm_device *dev, int output_reg, enum port port)
drm_sysfs_connector_add(connector);
intel_encoder->enable = intel_enable_dp;
+ intel_encoder->pre_enable = intel_pre_enable_dp;
intel_encoder->disable = intel_disable_dp;
+ intel_encoder->post_disable = intel_post_disable_dp;
intel_encoder->get_hw_state = intel_dp_get_hw_state;
intel_connector->get_hw_state = intel_connector_get_hw_state;
--
1.7.10.4
More information about the Intel-gfx
mailing list