[Intel-gfx] [PATCH 1/6] drm/i915: creating Haswell rc6 function
Paulo Zanoni
przanoni at gmail.com
Tue Feb 26 21:30:00 CET 2013
Hi
2 comments below:
2013/2/25 Rodrigo Vivi <rodrigo.vivi at gmail.com>:
> Power management, in special RC6 enabling, differs across platforms.
> This patch just split out enabling function for HSW.
>
> Signed-off-by: Rodrigo Vivi <rodrigo.vivi at gmail.com>
> ---
> drivers/gpu/drm/i915/intel_pm.c | 158 ++++++++++++++++++++++++++++++++++++----
> 1 file changed, 145 insertions(+), 13 deletions(-)
>
> diff --git a/drivers/gpu/drm/i915/intel_pm.c b/drivers/gpu/drm/i915/intel_pm.c
> index 61fee7f..e8656fd 100644
> --- a/drivers/gpu/drm/i915/intel_pm.c
> +++ b/drivers/gpu/drm/i915/intel_pm.c
> @@ -2581,15 +2581,10 @@ static void gen6_enable_rps(struct drm_device *dev)
> rc6_mode = intel_enable_rc6(dev_priv->dev);
> if (rc6_mode & INTEL_RC6_ENABLE)
> rc6_mask |= GEN6_RC_CTL_RC6_ENABLE;
> -
> - /* We don't use those on Haswell */
> - if (!IS_HASWELL(dev)) {
> - if (rc6_mode & INTEL_RC6p_ENABLE)
> - rc6_mask |= GEN6_RC_CTL_RC6p_ENABLE;
> -
> - if (rc6_mode & INTEL_RC6pp_ENABLE)
> - rc6_mask |= GEN6_RC_CTL_RC6pp_ENABLE;
> - }
> + if (rc6_mode & INTEL_RC6p_ENABLE)
> + rc6_mask |= GEN6_RC_CTL_RC6p_ENABLE;
Wrong indentation on the line above.
> + if (rc6_mode & INTEL_RC6pp_ENABLE)
> + rc6_mask |= GEN6_RC_CTL_RC6pp_ENABLE;
>
> DRM_INFO("Enabling RC6 states: RC6 %s, RC6p %s, RC6pp %s\n",
> (rc6_mask & GEN6_RC_CTL_RC6_ENABLE) ? "on" : "off",
> @@ -2625,7 +2620,141 @@ static void gen6_enable_rps(struct drm_device *dev)
> GEN6_RP_MEDIA_IS_GFX |
> GEN6_RP_ENABLE |
> GEN6_RP_UP_BUSY_AVG |
> - (IS_HASWELL(dev) ? GEN7_RP_DOWN_IDLE_AVG : GEN6_RP_DOWN_IDLE_CONT));
> + GEN6_RP_DOWN_IDLE_CONT);
> +
> + ret = sandybridge_pcode_write(dev_priv, GEN6_PCODE_WRITE_MIN_FREQ_TABLE, 0);
> + if (!ret) {
> + pcu_mbox = 0;
> + ret = sandybridge_pcode_read(dev_priv, GEN6_READ_OC_PARAMS, &pcu_mbox);
> + if (ret && pcu_mbox & (1<<31)) { /* OC supported */
> + dev_priv->rps.max_delay = pcu_mbox & 0xff;
> + DRM_DEBUG_DRIVER("overclocking supported, adjusting frequency max to %dMHz\n", pcu_mbox * 50);
> + }
> + } else {
> + DRM_DEBUG_DRIVER("Failed to set the min frequency\n");
> + }
> +
> + gen6_set_rps(dev_priv->dev, (gt_perf_status & 0xff00) >> 8);
> +
> + /* requires MSI enabled */
> + I915_WRITE(GEN6_PMIER, GEN6_PM_DEFERRED_EVENTS);
> + spin_lock_irq(&dev_priv->rps.lock);
> + WARN_ON(dev_priv->rps.pm_iir != 0);
> + I915_WRITE(GEN6_PMIMR, 0);
> + spin_unlock_irq(&dev_priv->rps.lock);
> + /* enable all PM interrupts */
> + I915_WRITE(GEN6_PMINTRMSK, 0);
> +
> + rc6vids = 0;
> + ret = sandybridge_pcode_read(dev_priv, GEN6_PCODE_READ_RC6VIDS, &rc6vids);
> + if (IS_GEN6(dev) && ret) {
> + DRM_DEBUG_DRIVER("Couldn't check for BIOS workaround\n");
> + } else if (IS_GEN6(dev) && (GEN6_DECODE_RC6_VID(rc6vids & 0xff) < 450)) {
> + DRM_DEBUG_DRIVER("You should update your BIOS. Correcting minimum rc6 voltage (%dmV->%dmV)\n",
> + GEN6_DECODE_RC6_VID(rc6vids & 0xff), 450);
> + rc6vids &= 0xffff00;
> + rc6vids |= GEN6_ENCODE_RC6_VID(450);
> + ret = sandybridge_pcode_write(dev_priv, GEN6_PCODE_WRITE_RC6VIDS, rc6vids);
> + if (ret)
> + DRM_ERROR("Couldn't fix incorrect rc6 voltage\n");
> + }
> +
> + gen6_gt_force_wake_put(dev_priv);
> +}
> +
> +static void hsw_enable_rps(struct drm_device *dev)
> +{
> + struct drm_i915_private *dev_priv = dev->dev_private;
> + struct intel_ring_buffer *ring;
> + u32 rp_state_cap;
> + u32 gt_perf_status;
> + u32 rc6vids, pcu_mbox, rc6_mask = 0;
> + u32 gtfifodbg;
> + int rc6_mode;
> + int i, ret;
> +
> + WARN_ON(!mutex_is_locked(&dev_priv->rps.hw_lock));
> +
> + /* Here begins a magic sequence of register writes to enable
> + * auto-downclocking.
> + *
> + * Perhaps there might be some value in exposing these to
> + * userspace...
> + */
> + I915_WRITE(GEN6_RC_STATE, 0);
> +
> + /* Clear the DBG now so we don't confuse earlier errors */
> + if ((gtfifodbg = I915_READ(GTFIFODBG))) {
> + DRM_ERROR("GT fifo had a previous error %x\n", gtfifodbg);
> + I915_WRITE(GTFIFODBG, gtfifodbg);
> + }
> +
> + gen6_gt_force_wake_get(dev_priv);
> +
> + rp_state_cap = I915_READ(GEN6_RP_STATE_CAP);
> + gt_perf_status = I915_READ(GEN6_GT_PERF_STATUS);
> +
> + /* In units of 100MHz */
> + dev_priv->rps.max_delay = rp_state_cap & 0xff;
> + dev_priv->rps.min_delay = (rp_state_cap & 0xff0000) >> 16;
> + dev_priv->rps.cur_delay = 0;
> +
> + /* disable the counters and set deterministic thresholds */
> + I915_WRITE(GEN6_RC_CONTROL, 0);
> +
> + I915_WRITE(GEN6_RC1_WAKE_RATE_LIMIT, 1000 << 16);
> + I915_WRITE(GEN6_RC6_WAKE_RATE_LIMIT, 40 << 16 | 30);
> + I915_WRITE(GEN6_RC6pp_WAKE_RATE_LIMIT, 30);
> + I915_WRITE(GEN6_RC_EVALUATION_INTERVAL, 125000);
> + I915_WRITE(GEN6_RC_IDLE_HYSTERSIS, 25);
> +
> + for_each_ring(ring, dev_priv, i)
> + I915_WRITE(RING_MAX_IDLE(ring->mmio_base), 10);
> +
> + I915_WRITE(GEN6_RC_SLEEP, 0);
> + I915_WRITE(GEN6_RC1e_THRESHOLD, 1000);
> + I915_WRITE(GEN6_RC6_THRESHOLD, 50000);
> + I915_WRITE(GEN6_RC6p_THRESHOLD, 100000);
> + I915_WRITE(GEN6_RC6pp_THRESHOLD, 64000); /* unused */
> +
> + /* Check if we are enabling RC6 */
> + rc6_mode = intel_enable_rc6(dev_priv->dev);
> + if (rc6_mode & INTEL_RC6_ENABLE)
> + rc6_mask |= GEN6_RC_CTL_RC6_ENABLE;
> +
> + DRM_INFO("Enabling RC6 states: RC6 %s\n",
> + (rc6_mask & GEN6_RC_CTL_RC6pp_ENABLE) ? "on" : "off");
s/GEN6_RC_CTL_RC6pp_ENABLE/GEN6_RC_CTL_RC6_ENABLE/
> +
> + I915_WRITE(GEN6_RC_CONTROL,
> + rc6_mask |
> + GEN6_RC_CTL_EI_MODE(1) |
> + GEN6_RC_CTL_HW_ENABLE);
> +
> + I915_WRITE(GEN6_RPNSWREQ,
> + GEN6_FREQUENCY(10) |
> + GEN6_OFFSET(0) |
> + GEN6_AGGRESSIVE_TURBO);
> + I915_WRITE(GEN6_RC_VIDEO_FREQ,
> + GEN6_FREQUENCY(12));
> +
> + I915_WRITE(GEN6_RP_DOWN_TIMEOUT, 1000000);
> + I915_WRITE(GEN6_RP_INTERRUPT_LIMITS,
> + dev_priv->rps.max_delay << 24 |
> + dev_priv->rps.min_delay << 16);
> +
> + I915_WRITE(GEN6_RP_UP_THRESHOLD, 59400);
> + I915_WRITE(GEN6_RP_DOWN_THRESHOLD, 245000);
> + I915_WRITE(GEN6_RP_UP_EI, 66000);
> + I915_WRITE(GEN6_RP_DOWN_EI, 350000);
> +
> + I915_WRITE(GEN6_RP_IDLE_HYSTERSIS, 10);
> + I915_WRITE(GEN6_RP_CONTROL,
> + GEN6_RP_MEDIA_TURBO |
> + GEN6_RP_MEDIA_HW_NORMAL_MODE |
> + GEN6_RP_MEDIA_IS_GFX |
> + GEN6_RP_ENABLE |
> + GEN6_RP_UP_BUSY_AVG |
> + GEN7_RP_DOWN_IDLE_AVG);
>
> ret = sandybridge_pcode_write(dev_priv, GEN6_PCODE_WRITE_MIN_FREQ_TABLE, 0);
> if (!ret) {
> @@ -3448,7 +3577,7 @@ void intel_disable_gt_powersave(struct drm_device *dev)
> }
> }
>
> -static void intel_gen6_powersave_work(struct work_struct *work)
> +static void intel_powersave_work(struct work_struct *work)
> {
> struct drm_i915_private *dev_priv =
> container_of(work, struct drm_i915_private,
> @@ -3456,7 +3585,10 @@ static void intel_gen6_powersave_work(struct work_struct *work)
> struct drm_device *dev = dev_priv->dev;
>
> mutex_lock(&dev_priv->rps.hw_lock);
> - gen6_enable_rps(dev);
> + if (IS_HASWELL(dev))
> + hsw_enable_rps(dev);
> + else
> + gen6_enable_rps(dev);
> gen6_update_ring_freq(dev);
> mutex_unlock(&dev_priv->rps.hw_lock);
> }
> @@ -4459,7 +4591,7 @@ void intel_gt_init(struct drm_device *dev)
> dev_priv->gt.force_wake_put = __gen6_gt_force_wake_put;
> }
> INIT_DELAYED_WORK(&dev_priv->rps.delayed_resume_work,
> - intel_gen6_powersave_work);
> + intel_powersave_work);
> }
>
> int sandybridge_pcode_read(struct drm_i915_private *dev_priv, u8 mbox, u32 *val)
> --
> 1.8.1.2
>
> _______________________________________________
> Intel-gfx mailing list
> Intel-gfx at lists.freedesktop.org
> http://lists.freedesktop.org/mailman/listinfo/intel-gfx
--
Paulo Zanoni
More information about the Intel-gfx
mailing list