[Intel-gfx] [PATCH] drm/i915: dump crtc timings from the pipe config

[Daniel Vetter]

On Thu, Sep 19, 2013 at 02:13:38PM +0100, Damien Lespiau wrote:
> On Thu, Sep 19, 2013 at 02:53:58PM +0200, Daniel Vetter wrote:
> > I always get royally confused how a modeline with all zeros could
> > possible pass the paranoid pipe config checker. Until I realize again
> > that we only check the crtc timings. So dump the crtc timings for the
> > adjusted mode.
> > 
> > This will be even more important for 3D support where the crtc timings
> > are markedly different from the input modeline if we have
> > frame-by-frame 3d output enabled.
> > 
> > Cc: Damien Lespiau <damien.lespiau at intel.com>
> > Signed-off-by: Daniel Vetter <daniel.vetter at ffwll.ch>
> 
> Reviewed-by: Damien Lespiau <damien.lespiau at intel.com>

Thanks for the review, and I guess more reasons for crtc_clock ;-) Patch
merged to dinq.
-Daniel
-- 
Daniel Vetter
Software Engineer, Intel Corporation
+41 (0) 79 365 57 48 - http://blog.ffwll.ch