[Intel-gfx] [PATCH 14/14] drm/i915: honour forced connector modes

[Rodrigo Vivi]

From: Chris Wilson <chris at chris-wilson.co.uk>

In the move over to use BIOS connector configs, we lost the ability to
force a specific set of connectors on or off.  Try to remedy that by
dropping back to the old behavior if we detect a hard coded connector
config that tries to enable a connector (disabling is easy!).

Based on earlier patches by Jesse Barnes.

Reported-by: Ville Syrjälä <ville.syrjala at linux.intel.com>
Signed-off-by: Chris Wilson <chris at chris-wilson.co.uk>
Cc: Jesse Barnes <jbarnes at virtuousgeek.org>
Cc: Ville Syrjälä <ville.syrjala at linux.intel.com>
Signed-off-by: Rodrigo Vivi <rodrigo.vivi at gmail.com>
---
 drivers/gpu/drm/i915/intel_fbdev.c | 15 ++++++++++++---
 1 file changed, 12 insertions(+), 3 deletions(-)

diff --git a/drivers/gpu/drm/i915/intel_fbdev.c b/drivers/gpu/drm/i915/intel_fbdev.c
index b4d44e6..bea2261 100644
--- a/drivers/gpu/drm/i915/intel_fbdev.c
+++ b/drivers/gpu/drm/i915/intel_fbdev.c
@@ -338,8 +338,18 @@ static bool intel_fb_initial_config(struct drm_fb_helper *fb_helper,
 			continue;
 		}
 
+		if (connector->force == DRM_FORCE_OFF) {
+			DRM_DEBUG_KMS("connector %d is disabled by user, skipping\n",
+				      connector->base.id);
+			enabled[i] = false;
+			continue;
+		}
+
 		encoder = connector->encoder;
 		if (!encoder || WARN_ON(!encoder->crtc)) {
+			if (connector->force > DRM_FORCE_OFF)
+				goto bail;
+
 			DRM_DEBUG_KMS("connector %d has no encoder or crtc, skipping\n",
 				      connector->base.id);
 			enabled[i] = false;
@@ -358,8 +368,7 @@ static bool intel_fb_initial_config(struct drm_fb_helper *fb_helper,
 		for (j = 0; j < fb_helper->connector_count; j++) {
 			if (crtcs[j] == new_crtc) {
 				DRM_DEBUG_KMS("fallback: cloned configuration\n");
-				fallback = true;
-				goto out;
+				goto bail;
 			}
 		}
 
@@ -417,8 +426,8 @@ static bool intel_fb_initial_config(struct drm_fb_helper *fb_helper,
 		fallback = true;
 	}
 
-out:
 	if (fallback) {
+bail:
 		DRM_DEBUG_KMS("Not using firmware configuration\n");
 		memcpy(enabled, save_enabled, dev->mode_config.num_connector);
 		kfree(save_enabled);
-- 
1.8.3.1