[Intel-gfx] [PATCH] gpu: drm: i915: intel_dp.c: Remove unused function

[Daniel Vetter]

On Sun, Dec 07, 2014 at 10:36:10PM +0100, Rickard Strandqvist wrote:
> Remove the function intel_dp_set_drrs_state() that is not used anywhere.
> 
> This was partially found by using a static code analysis program called cppcheck.
> 
> Signed-off-by: Rickard Strandqvist <rickard_strandqvist at spectrumdigital.se>

Ok I've merged one of these patches here for old stale code, but all the
others are in areas where there's a lot of stuff going on and we'll likely
use these functions again. So decided to drop those patches.

If you want to keep working on drm stuff I'd highly appreciate it. We have
a list of intro tasks which might be interesting:

http://www.x.org/wiki/DRMJanitors/

Nuking all the UMS checks might be a good one, we've already started with
that. And #intel-gfx irc on freenode is always a good place to hang out
and ask questions.

Cheers, Daniel
> ---
>  drivers/gpu/drm/i915/intel_dp.c  |   89 --------------------------------------
>  drivers/gpu/drm/i915/intel_drv.h |    1 -
>  2 files changed, 90 deletions(-)
> 
> diff --git a/drivers/gpu/drm/i915/intel_dp.c b/drivers/gpu/drm/i915/intel_dp.c
> index 5ad45bf..6df948b 100644
> --- a/drivers/gpu/drm/i915/intel_dp.c
> +++ b/drivers/gpu/drm/i915/intel_dp.c
> @@ -4810,95 +4810,6 @@ intel_dp_init_panel_power_sequencer_registers(struct drm_device *dev,
>  		      I915_READ(pp_div_reg));
>  }
>  
> -void intel_dp_set_drrs_state(struct drm_device *dev, int refresh_rate)
> -{
> -	struct drm_i915_private *dev_priv = dev->dev_private;
> -	struct intel_encoder *encoder;
> -	struct intel_dp *intel_dp = NULL;
> -	struct intel_crtc_config *config = NULL;
> -	struct intel_crtc *intel_crtc = NULL;
> -	struct intel_connector *intel_connector = dev_priv->drrs.connector;
> -	u32 reg, val;
> -	enum edp_drrs_refresh_rate_type index = DRRS_HIGH_RR;
> -
> -	if (refresh_rate <= 0) {
> -		DRM_DEBUG_KMS("Refresh rate should be positive non-zero.\n");
> -		return;
> -	}
> -
> -	if (intel_connector == NULL) {
> -		DRM_DEBUG_KMS("DRRS supported for eDP only.\n");
> -		return;
> -	}
> -
> -	/*
> -	 * FIXME: This needs proper synchronization with psr state. But really
> -	 * hard to tell without seeing the user of this function of this code.
> -	 * Check locking and ordering once that lands.
> -	 */
> -	if (INTEL_INFO(dev)->gen < 8 && intel_edp_is_psr_enabled(dev)) {
> -		DRM_DEBUG_KMS("DRRS is disabled as PSR is enabled\n");
> -		return;
> -	}
> -
> -	encoder = intel_attached_encoder(&intel_connector->base);
> -	intel_dp = enc_to_intel_dp(&encoder->base);
> -	intel_crtc = encoder->new_crtc;
> -
> -	if (!intel_crtc) {
> -		DRM_DEBUG_KMS("DRRS: intel_crtc not initialized\n");
> -		return;
> -	}
> -
> -	config = &intel_crtc->config;
> -
> -	if (intel_dp->drrs_state.type < SEAMLESS_DRRS_SUPPORT) {
> -		DRM_DEBUG_KMS("Only Seamless DRRS supported.\n");
> -		return;
> -	}
> -
> -	if (intel_connector->panel.downclock_mode->vrefresh == refresh_rate)
> -		index = DRRS_LOW_RR;
> -
> -	if (index == intel_dp->drrs_state.refresh_rate_type) {
> -		DRM_DEBUG_KMS(
> -			"DRRS requested for previously set RR...ignoring\n");
> -		return;
> -	}
> -
> -	if (!intel_crtc->active) {
> -		DRM_DEBUG_KMS("eDP encoder disabled. CRTC not Active\n");
> -		return;
> -	}
> -
> -	if (INTEL_INFO(dev)->gen > 6 && INTEL_INFO(dev)->gen < 8) {
> -		reg = PIPECONF(intel_crtc->config.cpu_transcoder);
> -		val = I915_READ(reg);
> -		if (index > DRRS_HIGH_RR) {
> -			val |= PIPECONF_EDP_RR_MODE_SWITCH;
> -			intel_dp_set_m_n(intel_crtc);
> -		} else {
> -			val &= ~PIPECONF_EDP_RR_MODE_SWITCH;
> -		}
> -		I915_WRITE(reg, val);
> -	}
> -
> -	/*
> -	 * mutex taken to ensure that there is no race between differnt
> -	 * drrs calls trying to update refresh rate. This scenario may occur
> -	 * in future when idleness detection based DRRS in kernel and
> -	 * possible calls from user space to set differnt RR are made.
> -	 */
> -
> -	mutex_lock(&intel_dp->drrs_state.mutex);
> -
> -	intel_dp->drrs_state.refresh_rate_type = index;
> -
> -	mutex_unlock(&intel_dp->drrs_state.mutex);
> -
> -	DRM_DEBUG_KMS("eDP Refresh Rate set to : %dHz\n", refresh_rate);
> -}
> -
>  static struct drm_display_mode *
>  intel_dp_drrs_init(struct intel_digital_port *intel_dig_port,
>  			struct intel_connector *intel_connector,
> diff --git a/drivers/gpu/drm/i915/intel_drv.h b/drivers/gpu/drm/i915/intel_drv.h
> index ba71522..6ad239d 100644
> --- a/drivers/gpu/drm/i915/intel_drv.h
> +++ b/drivers/gpu/drm/i915/intel_drv.h
> @@ -941,7 +941,6 @@ void intel_edp_panel_on(struct intel_dp *intel_dp);
>  void intel_edp_panel_off(struct intel_dp *intel_dp);
>  void intel_edp_psr_enable(struct intel_dp *intel_dp);
>  void intel_edp_psr_disable(struct intel_dp *intel_dp);
> -void intel_dp_set_drrs_state(struct drm_device *dev, int refresh_rate);
>  void intel_edp_psr_invalidate(struct drm_device *dev,
>  			      unsigned frontbuffer_bits);
>  void intel_edp_psr_flush(struct drm_device *dev,
> -- 
> 1.7.10.4
> 
> _______________________________________________
> dri-devel mailing list
> dri-devel at lists.freedesktop.org
> http://lists.freedesktop.org/mailman/listinfo/dri-devel

-- 
Daniel Vetter
Software Engineer, Intel Corporation
+41 (0) 79 365 57 48 - http://blog.ffwll.ch