[Intel-gfx] [PATCH] drm/i915: don't disable DP port after a failed link training

[Daniel Vetter]

On Fri, Jan 17, 2014 at 01:58:43PM +0000, Chris Wilson wrote:
> On Fri, Jan 17, 2014 at 03:46:43PM +0200, Imre Deak wrote:
> > Atm after a failed link training we disable the DP port. This can happen
> > during a modeset-enable or a DP link re-establishment. The latter can be
> > a problem and we shouldn't disable the DP port, see the previous patch for
> > the reasoning. In the former case the right thing would be to disable
> > the DP port, but also the rest of the pipe.
> > 
> > As a stop-gap solution leave the DP port enabled in both cases. It is an
> > improvement on its own (avoiding HW lock ups) and the proper solution
> > for the first case requires a bigger change, so let's keep that on the
> > TODO list.
> > 
> > v2:
> > - fix explanation of change impact (Chris)
> > 
> > Suggested-by: Daniel Vetter <daniel at ffwll.ch>
> > Signed-off-by: Imre Deak <imre.deak at intel.com>
> Reviewed-by: Chris Wilson <chris at chris-wilson.co.uk>
> and r-b for patch 1 as well (if I didn't send it).

Both merged, thanks.
-Daniel
> -Chris
> 
> -- 
> Chris Wilson, Intel Open Source Technology Centre
> _______________________________________________
> Intel-gfx mailing list
> Intel-gfx at lists.freedesktop.org
> http://lists.freedesktop.org/mailman/listinfo/intel-gfx

-- 
Daniel Vetter
Software Engineer, Intel Corporation
+41 (0) 79 365 57 48 - http://blog.ffwll.ch