[Intel-gfx] [PATCH v8 2/2] drm/i915: State readout and cross-checking for dp_m2_n2
Vandana Kannan
vandana.kannan at intel.com
Fri Jul 11 11:02:58 CEST 2014
Adding relevant read out comparison code, in check_crtc_state, for the new
member of crtc_config, dp_m2_n2, which was introduced to store link_m_n
values for a DP downclock mode (if available). Suggested by Daniel.
v2: Changed patch title.
Daniel's review comments incorporated.
Added relevant state readout code for M2_N2. dp_m2_n2 comparison to be done
only when high RR is not in use (This is because alternate m_n register
programming will be done only when low RR is being used).
v3: Modified call to get_m2_n2 which had dp_m_n as param by mistake.
Compare dp_m_n and dp_m2_n2 for gen 7 and below. compare the structures
based on DRRS state for gen 8 and above.
Save and restore M2 N2 registers for gen 7 and below
v4: For Gen>=8, check M_N registers against dp_m_n and dp_m2_n2 as there is
only one set of M_N registers
v5: Removed the chunk which saves and restores M2_N2 registers. Modified
get_m_n() to get M2_N2 registers as well. Modified the macro which compares
hw.dp_m_n against sw.dp_m2_n2/sw.dp_m_n for gen > 8.
v6: Added check to compare dp_m2_n2 only when DRRS is enabled
v7: Modified drrs check to use has_drrs
v8: Add has_drrs check before reading M2_N2 registers
Signed-off-by: Vandana Kannan <vandana.kannan at intel.com>
Cc: Daniel Vetter <daniel.vetter at ffwll.ch>
Cc: Jani Nikula <jani.nikula at linux.intel.com>
Cc: Jesse Barnes <jbarnes at virtuousgeek.org>
---
drivers/gpu/drm/i915/intel_display.c | 75 ++++++++++++++++++++++++++++++++----
1 file changed, 67 insertions(+), 8 deletions(-)
diff --git a/drivers/gpu/drm/i915/intel_display.c b/drivers/gpu/drm/i915/intel_display.c
index 9f651a6..87481f4 100644
--- a/drivers/gpu/drm/i915/intel_display.c
+++ b/drivers/gpu/drm/i915/intel_display.c
@@ -7138,7 +7138,8 @@ static void intel_pch_transcoder_get_m_n(struct intel_crtc *crtc,
static void intel_cpu_transcoder_get_m_n(struct intel_crtc *crtc,
enum transcoder transcoder,
- struct intel_link_m_n *m_n)
+ struct intel_link_m_n *m_n,
+ struct intel_link_m_n *m2_n2)
{
struct drm_device *dev = crtc->base.dev;
struct drm_i915_private *dev_priv = dev->dev_private;
@@ -7152,6 +7153,20 @@ static void intel_cpu_transcoder_get_m_n(struct intel_crtc *crtc,
m_n->gmch_n = I915_READ(PIPE_DATA_N1(transcoder));
m_n->tu = ((I915_READ(PIPE_DATA_M1(transcoder))
& TU_SIZE_MASK) >> TU_SIZE_SHIFT) + 1;
+ /* Read M2_N2 registers only for gen < 8 (M2_N2 available for
+ * gen < 8) and if DRRS is supported (to make sure the
+ * registers are not unnecessarily read).
+ */
+ if (m2_n2 && INTEL_INFO(dev)->gen < 8 &&
+ crtc->config.has_drrs) {
+ m2_n2->link_m = I915_READ(PIPE_LINK_M2(transcoder));
+ m2_n2->link_n = I915_READ(PIPE_LINK_N2(transcoder));
+ m2_n2->gmch_m = I915_READ(PIPE_DATA_M2(transcoder))
+ & ~TU_SIZE_MASK;
+ m2_n2->gmch_n = I915_READ(PIPE_DATA_N2(transcoder));
+ m2_n2->tu = ((I915_READ(PIPE_DATA_M2(transcoder))
+ & TU_SIZE_MASK) >> TU_SIZE_SHIFT) + 1;
+ }
} else {
m_n->link_m = I915_READ(PIPE_LINK_M_G4X(pipe));
m_n->link_n = I915_READ(PIPE_LINK_N_G4X(pipe));
@@ -7170,14 +7185,15 @@ void intel_dp_get_m_n(struct intel_crtc *crtc,
intel_pch_transcoder_get_m_n(crtc, &pipe_config->dp_m_n);
else
intel_cpu_transcoder_get_m_n(crtc, pipe_config->cpu_transcoder,
- &pipe_config->dp_m_n);
+ &pipe_config->dp_m_n,
+ &pipe_config->dp_m2_n2);
}
static void ironlake_get_fdi_m_n_config(struct intel_crtc *crtc,
struct intel_crtc_config *pipe_config)
{
intel_cpu_transcoder_get_m_n(crtc, pipe_config->cpu_transcoder,
- &pipe_config->fdi_m_n);
+ &pipe_config->fdi_m_n, NULL);
}
static void ironlake_get_pfit_config(struct intel_crtc *crtc,
@@ -9932,6 +9948,15 @@ static void intel_dump_pipe_config(struct intel_crtc *crtc,
pipe_config->dp_m_n.gmch_m, pipe_config->dp_m_n.gmch_n,
pipe_config->dp_m_n.link_m, pipe_config->dp_m_n.link_n,
pipe_config->dp_m_n.tu);
+
+ DRM_DEBUG_KMS("dp: %i, gmch_m2: %u, gmch_n2: %u, link_m2: %u, link_n2: %u, tu2: %u\n",
+ pipe_config->has_dp_encoder,
+ pipe_config->dp_m2_n2.gmch_m,
+ pipe_config->dp_m2_n2.gmch_n,
+ pipe_config->dp_m2_n2.link_m,
+ pipe_config->dp_m2_n2.link_n,
+ pipe_config->dp_m2_n2.tu);
+
DRM_DEBUG_KMS("requested mode:\n");
drm_mode_debug_printmodeline(&pipe_config->requested_mode);
DRM_DEBUG_KMS("adjusted mode:\n");
@@ -10312,6 +10337,22 @@ intel_pipe_config_compare(struct drm_device *dev,
return false; \
}
+/* This is required for BDW+ where there is only one set of registers for
+ * switching between high and low RR.
+ * This macro can be used whenever a comparison has to be made between one
+ * hw state and multiple sw state variables.
+ */
+#define PIPE_CONF_CHECK_I_ALT(name, alt_name) \
+ if ((current_config->name != pipe_config->name) && \
+ (current_config->alt_name != pipe_config->name)) { \
+ DRM_ERROR("mismatch in " #name " " \
+ "(expected %i or %i, found %i)\n", \
+ current_config->name, \
+ current_config->alt_name, \
+ pipe_config->name); \
+ return false; \
+ }
+
#define PIPE_CONF_CHECK_FLAGS(name, mask) \
if ((current_config->name ^ pipe_config->name) & (mask)) { \
DRM_ERROR("mismatch in " #name "(" #mask ") " \
@@ -10344,11 +10385,28 @@ intel_pipe_config_compare(struct drm_device *dev,
PIPE_CONF_CHECK_I(fdi_m_n.tu);
PIPE_CONF_CHECK_I(has_dp_encoder);
- PIPE_CONF_CHECK_I(dp_m_n.gmch_m);
- PIPE_CONF_CHECK_I(dp_m_n.gmch_n);
- PIPE_CONF_CHECK_I(dp_m_n.link_m);
- PIPE_CONF_CHECK_I(dp_m_n.link_n);
- PIPE_CONF_CHECK_I(dp_m_n.tu);
+
+ if (INTEL_INFO(dev)->gen < 8) {
+ PIPE_CONF_CHECK_I(dp_m_n.gmch_m);
+ PIPE_CONF_CHECK_I(dp_m_n.gmch_n);
+ PIPE_CONF_CHECK_I(dp_m_n.link_m);
+ PIPE_CONF_CHECK_I(dp_m_n.link_n);
+ PIPE_CONF_CHECK_I(dp_m_n.tu);
+
+ if (current_config->has_drrs) {
+ PIPE_CONF_CHECK_I(dp_m2_n2.gmch_m);
+ PIPE_CONF_CHECK_I(dp_m2_n2.gmch_n);
+ PIPE_CONF_CHECK_I(dp_m2_n2.link_m);
+ PIPE_CONF_CHECK_I(dp_m2_n2.link_n);
+ PIPE_CONF_CHECK_I(dp_m2_n2.tu);
+ }
+ } else {
+ PIPE_CONF_CHECK_I_ALT(dp_m_n.gmch_m, dp_m2_n2.gmch_m);
+ PIPE_CONF_CHECK_I_ALT(dp_m_n.gmch_n, dp_m2_n2.gmch_n);
+ PIPE_CONF_CHECK_I_ALT(dp_m_n.link_m, dp_m2_n2.link_m);
+ PIPE_CONF_CHECK_I_ALT(dp_m_n.link_n, dp_m2_n2.link_n);
+ PIPE_CONF_CHECK_I_ALT(dp_m_n.tu, dp_m2_n2.tu);
+ }
PIPE_CONF_CHECK_I(adjusted_mode.crtc_hdisplay);
PIPE_CONF_CHECK_I(adjusted_mode.crtc_htotal);
@@ -10431,6 +10489,7 @@ intel_pipe_config_compare(struct drm_device *dev,
#undef PIPE_CONF_CHECK_X
#undef PIPE_CONF_CHECK_I
+#undef PIPE_CONF_CHECK_I_ALT
#undef PIPE_CONF_CHECK_FLAGS
#undef PIPE_CONF_CHECK_CLOCK_FUZZY
#undef PIPE_CONF_QUIRK
--
1.9.3
More information about the Intel-gfx
mailing list