[Intel-gfx] [PATCH] drm/i915/chv: Use timeout mode for RC6 on chv

[deepak.s at linux.intel.com]

From: Deepak S <deepak.s at linux.intel.com>

Higher RC6 residency is observed using timeout mode
instead of EI mode. It's Recommended to use TO Method for RC6.

Signed-off-by: Deepak S <deepak.s at linux.intel.com>
---
 drivers/gpu/drm/i915/intel_pm.c | 4 ++--
 1 file changed, 2 insertions(+), 2 deletions(-)

diff --git a/drivers/gpu/drm/i915/intel_pm.c b/drivers/gpu/drm/i915/intel_pm.c
index 19c5c26..88bad36 100644
--- a/drivers/gpu/drm/i915/intel_pm.c
+++ b/drivers/gpu/drm/i915/intel_pm.c
@@ -4037,7 +4037,7 @@ static void cherryview_enable_rps(struct drm_device *dev)
 		I915_WRITE(RING_MAX_IDLE(ring->mmio_base), 10);
 	I915_WRITE(GEN6_RC_SLEEP, 0);
 
-	I915_WRITE(GEN6_RC6_THRESHOLD, 50000); /* 50/125ms per EI */
+	I915_WRITE(GEN6_RC6_THRESHOLD, 0x557);
 
 	/* allows RC6 residency counter to work */
 	I915_WRITE(VLV_COUNTER_CONTROL,
@@ -4053,7 +4053,7 @@ static void cherryview_enable_rps(struct drm_device *dev)
 	/* 3: Enable RC6 */
 	if ((intel_enable_rc6(dev) & INTEL_RC6_ENABLE) &&
 						(pcbr >> VLV_PCBR_ADDR_SHIFT))
-		rc6_mode = GEN6_RC_CTL_EI_MODE(1);
+		rc6_mode = GEN7_RC_CTL_TO_MODE;
 
 	I915_WRITE(GEN6_RC_CONTROL, rc6_mode);
 
-- 
1.9.1