[Intel-gfx] [v2] drm/i915: vlv_prepare_pll is only needed in case of non DSI interfaces

Shobhit Kumar shobhit.kumar at intel.com
Wed Jun 25 08:50:39 CEST 2014


For MIPI, DSI PLL is configured separately in vlv_configure_dsi_pll
during the DSI enable sequence

Causing WARN dump otherwise in dpio_reads

v2: Add IS_CHERRYVIEW check as suggested by Ville

Signed-off-by: Shobhit Kumar <shobhit.kumar at intel.com>
Reviewed-by: Ville Syrjälä <ville.syrjala at linux.intel.com>
---
 drivers/gpu/drm/i915/intel_display.c | 7 ++++---
 1 file changed, 4 insertions(+), 3 deletions(-)

diff --git a/drivers/gpu/drm/i915/intel_display.c b/drivers/gpu/drm/i915/intel_display.c
index fa77557..2af7b6f 100644
--- a/drivers/gpu/drm/i915/intel_display.c
+++ b/drivers/gpu/drm/i915/intel_display.c
@@ -4629,7 +4629,10 @@ static void valleyview_crtc_enable(struct drm_crtc *crtc)
 	if (intel_crtc->active)
 		return;
 
-	vlv_prepare_pll(intel_crtc);
+	is_dsi = intel_pipe_has_type(crtc, INTEL_OUTPUT_DSI);
+
+	if (!is_dsi && !IS_CHERRYVIEW(dev))
+		vlv_prepare_pll(intel_crtc);
 
 	/* Set up the display plane register */
 	dspcntr = DISPPLANE_GAMMA_ENABLE;
@@ -4663,8 +4666,6 @@ static void valleyview_crtc_enable(struct drm_crtc *crtc)
 		if (encoder->pre_pll_enable)
 			encoder->pre_pll_enable(encoder);
 
-	is_dsi = intel_pipe_has_type(crtc, INTEL_OUTPUT_DSI);
-
 	if (!is_dsi) {
 		if (IS_CHERRYVIEW(dev))
 			chv_enable_pll(intel_crtc);
-- 
1.9.1




More information about the Intel-gfx mailing list