[Intel-gfx] [PATCH 3/3] drm/i915: Make sure vsyncshift is positive

[ville.syrjala at linux.intel.com]

From: Ville Syrjälä <ville.syrjala at linux.intel.com>

If vsyncshift comes out as negative, add one htotal to it to get the
corresponding positive value.

This is rather theoretical as it would require a mode where the
hsync+back porch is very long and the active+front porch very short.

Signed-off-by: Ville Syrjälä <ville.syrjala at linux.intel.com>
---
 drivers/gpu/drm/i915/intel_display.c | 5 ++++-
 1 file changed, 4 insertions(+), 1 deletion(-)

diff --git a/drivers/gpu/drm/i915/intel_display.c b/drivers/gpu/drm/i915/intel_display.c
index 3ab40e3..7d3b18b 100644
--- a/drivers/gpu/drm/i915/intel_display.c
+++ b/drivers/gpu/drm/i915/intel_display.c
@@ -5377,7 +5377,8 @@ static void intel_set_pipe_timings(struct intel_crtc *intel_crtc)
 	enum transcoder cpu_transcoder = intel_crtc->config.cpu_transcoder;
 	struct drm_display_mode *adjusted_mode =
 		&intel_crtc->config.adjusted_mode;
-	uint32_t vsyncshift = 0, crtc_vtotal, crtc_vblank_end;
+	uint32_t crtc_vtotal, crtc_vblank_end;
+	int vsyncshift = 0;
 
 	/* We need to be careful not to changed the adjusted mode, for otherwise
 	 * the hw state checker will get angry at the mismatch. */
@@ -5394,6 +5395,8 @@ static void intel_set_pipe_timings(struct intel_crtc *intel_crtc)
 		else
 			vsyncshift = adjusted_mode->crtc_hsync_start -
 				adjusted_mode->crtc_htotal / 2;
+		if (vsyncshift < 0)
+			vsyncshift += adjusted_mode->crtc_htotal;
 	}
 
 	if (INTEL_INFO(dev)->gen > 3)
-- 
1.8.3.2