[Intel-gfx] [PATCH v3] drm/i915: rewrite hsw/bdw audio codec enable/disable sequences
Rodrigo Vivi
rodrigo.vivi at gmail.com
Wed Oct 29 22:49:33 CET 2014
On Tue, Oct 28, 2014 at 5:03 AM, Jani Nikula <jani.nikula at intel.com> wrote:
> There's some serious confusion regarding ELD valid bit that gets set and
> cleared back and forth etc. Rewrite it all based on the documented audio
> codec enable/disable sequences.
>
> v3: replace vblank wait with a comment
Why did you remove the vblank wait? seemed correct by spec you
pointed... at least looking to BDW one...
>
> Signed-off-by: Jani Nikula <jani.nikula at intel.com>
> ---
> drivers/gpu/drm/i915/intel_audio.c | 110 ++++++++++++++++---------------------
> 1 file changed, 46 insertions(+), 64 deletions(-)
>
> diff --git a/drivers/gpu/drm/i915/intel_audio.c b/drivers/gpu/drm/i915/intel_audio.c
> index 821514c95229..2e7d42878b9d 100644
> --- a/drivers/gpu/drm/i915/intel_audio.c
> +++ b/drivers/gpu/drm/i915/intel_audio.c
> @@ -132,14 +132,26 @@ static void g4x_audio_codec_enable(struct drm_connector *connector,
>
> static void hsw_audio_codec_disable(struct intel_encoder *encoder)
> {
> - struct drm_device *dev = encoder->base.dev;
> - struct drm_i915_private *dev_priv = dev->dev_private;
> - struct drm_crtc *crtc = encoder->base.crtc;
> - enum pipe pipe = to_intel_crtc(crtc)->pipe;
> + struct drm_i915_private *dev_priv = encoder->base.dev->dev_private;
> + struct intel_crtc *intel_crtc = to_intel_crtc(encoder->base.crtc);
> + enum pipe pipe = intel_crtc->pipe;
> uint32_t tmp;
>
> + DRM_DEBUG_KMS("Disable audio codec on pipe %c\n", pipe_name(pipe));
> +
> + /* Disable timestamps */
> + tmp = I915_READ(HSW_AUD_CFG(pipe));
> + tmp &= ~AUD_CONFIG_N_VALUE_INDEX;
> + tmp |= AUD_CONFIG_N_PROG_ENABLE;
> + tmp &= ~AUD_CONFIG_UPPER_N_MASK;
> + tmp &= ~AUD_CONFIG_LOWER_N_MASK;
> + if (intel_pipe_has_type(intel_crtc, INTEL_OUTPUT_DISPLAYPORT))
> + tmp |= AUD_CONFIG_N_VALUE_INDEX;
> + I915_WRITE(HSW_AUD_CFG(pipe), tmp);
> +
> + /* Invalidate ELD */
> tmp = I915_READ(HSW_AUD_PIN_ELD_CP_VLD);
> - tmp &= ~((AUDIO_OUTPUT_ENABLE_A | AUDIO_ELD_VALID_A) << (pipe * 4));
> + tmp &= ~(AUDIO_ELD_VALID_A << (pipe * 4));
> I915_WRITE(HSW_AUD_PIN_ELD_CP_VLD, tmp);
> }
>
> @@ -149,77 +161,47 @@ static void hsw_audio_codec_enable(struct drm_connector *connector,
> {
> struct drm_i915_private *dev_priv = connector->dev->dev_private;
> struct intel_crtc *intel_crtc = to_intel_crtc(encoder->base.crtc);
> - uint8_t *eld = connector->eld;
> - uint32_t eldv;
> + enum pipe pipe = intel_crtc->pipe;
> + const uint8_t *eld = connector->eld;
> uint32_t tmp;
> int len, i;
> - enum pipe pipe = intel_crtc->pipe;
> - enum port port;
> - int hdmiw_hdmiedid = HSW_AUD_EDID_DATA(pipe);
> - int aud_cntl_st = HSW_AUD_DIP_ELD_CTRL(pipe);
> - int aud_config = HSW_AUD_CFG(pipe);
> - int aud_cntrl_st2 = HSW_AUD_PIN_ELD_CP_VLD;
>
> - /* Audio output enable */
> - DRM_DEBUG_DRIVER("HDMI audio: enable codec\n");
> - tmp = I915_READ(aud_cntrl_st2);
> - tmp |= (AUDIO_OUTPUT_ENABLE_A << (pipe * 4));
> - I915_WRITE(aud_cntrl_st2, tmp);
> - POSTING_READ(aud_cntrl_st2);
> -
> - /* Set ELD valid state */
> - tmp = I915_READ(aud_cntrl_st2);
> - DRM_DEBUG_DRIVER("HDMI audio: pin eld vld status=0x%08x\n", tmp);
> - tmp |= (AUDIO_ELD_VALID_A << (pipe * 4));
> - I915_WRITE(aud_cntrl_st2, tmp);
> - tmp = I915_READ(aud_cntrl_st2);
> - DRM_DEBUG_DRIVER("HDMI audio: eld vld status=0x%08x\n", tmp);
> -
> - /* Enable HDMI mode */
> - tmp = I915_READ(aud_config);
> - DRM_DEBUG_DRIVER("HDMI audio: audio conf: 0x%08x\n", tmp);
> - /* clear N_programing_enable and N_value_index */
> - tmp &= ~(AUD_CONFIG_N_VALUE_INDEX | AUD_CONFIG_N_PROG_ENABLE);
> - I915_WRITE(aud_config, tmp);
> + DRM_DEBUG_KMS("Enable audio codec on pipe %c, %u bytes ELD\n",
> + pipe_name(pipe), eld[2]);
>
> - DRM_DEBUG_DRIVER("ELD on pipe %c\n", pipe_name(pipe));
> -
> - eldv = AUDIO_ELD_VALID_A << (pipe * 4);
> -
> - if (intel_pipe_has_type(intel_crtc, INTEL_OUTPUT_DISPLAYPORT))
> - I915_WRITE(aud_config, AUD_CONFIG_N_VALUE_INDEX); /* 0x1 = DP */
> - else
> - I915_WRITE(aud_config, audio_config_hdmi_pixel_clock(mode));
> -
> - if (intel_eld_uptodate(connector,
> - aud_cntrl_st2, eldv,
> - aud_cntl_st, IBX_ELD_ADDRESS_MASK,
> - hdmiw_hdmiedid))
> - return;
> + /* Enable audio presence detect, invalidate ELD */
> + tmp = I915_READ(HSW_AUD_PIN_ELD_CP_VLD);
> + tmp |= AUDIO_OUTPUT_ENABLE_A << (pipe * 4);
> + tmp &= ~(AUDIO_ELD_VALID_A << (pipe * 4));
> + I915_WRITE(HSW_AUD_PIN_ELD_CP_VLD, tmp);
>
> - tmp = I915_READ(aud_cntrl_st2);
> - tmp &= ~eldv;
> - I915_WRITE(aud_cntrl_st2, tmp);
> + /* XXX: vblank wait here */
>
> - tmp = I915_READ(aud_cntl_st);
> + /* Reset ELD write address */
> + tmp = I915_READ(HSW_AUD_DIP_ELD_CTRL(pipe));
> tmp &= ~IBX_ELD_ADDRESS_MASK;
> - I915_WRITE(aud_cntl_st, tmp);
> - port = (tmp >> 29) & DIP_PORT_SEL_MASK; /* DIP_Port_Select, 0x1 = PortB */
> - DRM_DEBUG_DRIVER("port num:%d\n", port);
> + I915_WRITE(HSW_AUD_DIP_ELD_CTRL(pipe), tmp);
>
> - len = min_t(int, eld[2], 21); /* 84 bytes of hw ELD buffer */
> - DRM_DEBUG_DRIVER("ELD size %d\n", len);
> + /* Up to 84 bytes of hw ELD buffer */
> + len = min_t(int, eld[2], 21);
> for (i = 0; i < len; i++)
> - I915_WRITE(hdmiw_hdmiedid, *((uint32_t *)eld + i));
> -
> - tmp = I915_READ(aud_cntrl_st2);
> - tmp |= eldv;
> - I915_WRITE(aud_cntrl_st2, tmp);
> + I915_WRITE(HSW_AUD_EDID_DATA(pipe), *((uint32_t *)eld + i));
>
> - /* XXX: Transitional */
> + /* ELD valid */
> tmp = I915_READ(HSW_AUD_PIN_ELD_CP_VLD);
> - tmp |= ((AUDIO_OUTPUT_ENABLE_A | AUDIO_ELD_VALID_A) << (pipe * 4));
> + tmp |= AUDIO_ELD_VALID_A << (pipe * 4);
> I915_WRITE(HSW_AUD_PIN_ELD_CP_VLD, tmp);
> +
> + /* Enable timestamps */
> + tmp = I915_READ(HSW_AUD_CFG(pipe));
> + tmp &= ~AUD_CONFIG_N_VALUE_INDEX;
> + tmp &= ~AUD_CONFIG_N_PROG_ENABLE;
> + tmp &= ~AUD_CONFIG_PIXEL_CLOCK_HDMI_MASK;
> + if (intel_pipe_has_type(intel_crtc, INTEL_OUTPUT_DISPLAYPORT))
> + tmp |= AUD_CONFIG_N_VALUE_INDEX;
> + else
> + tmp |= audio_config_hdmi_pixel_clock(mode);
> + I915_WRITE(HSW_AUD_CFG(pipe), tmp);
> }
>
> static void ilk_audio_codec_enable(struct drm_connector *connector,
> --
> 2.1.1
>
--
Rodrigo Vivi
Blog: http://blog.vivi.eng.br
More information about the Intel-gfx
mailing list