[Intel-gfx] [PATCH 04/10] drm/i915: Add a delay in Displayport AUX transactions for compliance testing

[Daniel Vetter]

On Wed, Apr 15, 2015 at 08:38:41AM -0700, Todd Previte wrote:
> The Displayport Link Layer Compliance Testing Specification 1.2 rev 1.1
> specifies that repeated AUX transactions after a failure (no response /
> invalid response) must have a minimum delay of 400us before the resend can
> occur. Tests 4.2.1.1 and 4.2.1.2 are two tests that require this specifically.
> 
> Also, the check for DP_AUX_CH_CTL_TIME_OUT_ERROR has been moved out into a
> separate case. This case just continues with the next iteration of the loop
> as the HW has already waited the required amount of time.
> 
> V2:
> - Changed udelay() to usleep_range()
> V3:
> - Removed extraneous check for timeout
> - Updated comment to reflect this change
> V4:
> - Reformatted a comment
> V5:
> - Added separate check for HW timeout on AUX transactions. A message
>   is logged upon detection of this case.
> V6:
> - Add continue statement to HW timeout detect case
> - Remove the log message indicating a timeout has been
>   detected (review feedback)
> V7:
> - Updated the commit message to remove verbage about the HW timeout
>   case that is no longer valid.
> 
> Signed-off-by: Todd Previte <tprevite at gmail.com>
> Reviewed-by: Paulo Zanoni <paulo.r.zanoni at intel.com>

Queued for -next, thanks for the patch.
-Daniel

> ---
>  drivers/gpu/drm/i915/intel_dp.c | 13 +++++++++++--
>  1 file changed, 11 insertions(+), 2 deletions(-)
> 
> diff --git a/drivers/gpu/drm/i915/intel_dp.c b/drivers/gpu/drm/i915/intel_dp.c
> index c112359..dae5c9a 100644
> --- a/drivers/gpu/drm/i915/intel_dp.c
> +++ b/drivers/gpu/drm/i915/intel_dp.c
> @@ -874,9 +874,18 @@ intel_dp_aux_ch(struct intel_dp *intel_dp,
>  				   DP_AUX_CH_CTL_TIME_OUT_ERROR |
>  				   DP_AUX_CH_CTL_RECEIVE_ERROR);
>  
> -			if (status & (DP_AUX_CH_CTL_TIME_OUT_ERROR |
> -				      DP_AUX_CH_CTL_RECEIVE_ERROR))
> +			if (status & DP_AUX_CH_CTL_TIME_OUT_ERROR)
>  				continue;
> +
> +			/* DP CTS 1.2 Core Rev 1.1, 4.2.1.1 & 4.2.1.2
> +			 *   400us delay required for errors and timeouts
> +			 *   Timeout errors from the HW already meet this
> +			 *   requirement so skip to next iteration
> +			 */
> +			if (status & DP_AUX_CH_CTL_RECEIVE_ERROR) {
> +				usleep_range(400, 500);
> +				continue;
> +			}
>  			if (status & DP_AUX_CH_CTL_DONE)
>  				break;
>  		}
> -- 
> 1.9.1
> 
> _______________________________________________
> Intel-gfx mailing list
> Intel-gfx at lists.freedesktop.org
> http://lists.freedesktop.org/mailman/listinfo/intel-gfx

-- 
Daniel Vetter
Software Engineer, Intel Corporation
http://blog.ffwll.ch