[Intel-gfx] [DMC-REDESIGN-PATCHES 01/12] drm/i915: use correct power domain for csr loading

[Animesh Manna]

From: Daniel Vetter <daniel.vetter at ffwll.ch>

Grabbing a runtime pm reference with intel_runtime_pm_get will only
prevent device D3. But dmc firmware is required even earlier (namely
for the skl power well 2).

Hence we need to grab a rpm reference higher up in the hierarchy. For
simplicity just grab the _INIT display power well. That's a bit too
much, but since the firmware loading task should completely fairly
quickly this won't be a real problem really.

Cc: Damien Lespiau <damien.lespiau at intel.com>
Cc: Imre Deak <imre.deak at intel.com>
Cc: Sunil Kamath <sunil.kamath at intel.com>
Signed-off-by: Daniel Vetter <daniel.vetter at intel.com>
Signed-off-by: Animesh Manna <animesh.manna at intel.com>
---
 drivers/gpu/drm/i915/intel_csr.c | 4 ++--
 1 file changed, 2 insertions(+), 2 deletions(-)

diff --git a/drivers/gpu/drm/i915/intel_csr.c b/drivers/gpu/drm/i915/intel_csr.c
index ba1ae03..bd4a4a9 100644
--- a/drivers/gpu/drm/i915/intel_csr.c
+++ b/drivers/gpu/drm/i915/intel_csr.c
@@ -384,7 +384,7 @@ static void finish_csr_load(const struct firmware *fw, void *context)
 	DRM_DEBUG_KMS("Finished loading %s\n", dev_priv->csr.fw_path);
 out:
 	if (fw_loaded)
-		intel_runtime_pm_put(dev_priv);
+		intel_display_power_put(dev_priv, POWER_DOMAIN_INIT);
 	else
 		intel_csr_load_status_set(dev_priv, FW_FAILED);
 
@@ -421,7 +421,7 @@ void intel_csr_ucode_init(struct drm_device *dev)
 	 * Obtain a runtime pm reference, until CSR is loaded,
 	 * to avoid entering runtime-suspend.
 	 */
-	intel_runtime_pm_get(dev_priv);
+	intel_display_power_get(dev_priv, POWER_DOMAIN_INIT);
 
 	/* CSR supported for platform, load firmware */
 	ret = request_firmware_nowait(THIS_MODULE, true, csr->fw_path,
-- 
2.0.2