[Intel-gfx] [PATCH v4] drm/i915: Disable fast link training if DP config changes
Ville Syrjälä
ville.syrjala at linux.intel.com
Fri Dec 18 07:57:44 PST 2015
On Fri, Dec 18, 2015 at 10:37:26AM +0200, Mika Kahola wrote:
> On Thu, 2015-12-17 at 15:16 +0200, Ville Syrjälä wrote:
> > On Thu, Dec 17, 2015 at 02:46:03PM +0200, Mika Kahola wrote:
> > > Disable DP fast link training if DP link configuration
> > > changes. If one of the DP link parameters i.e. link
> > > bandwidth, lane count, rate selection, port clock or bpp
> >
> > This list of things we check should be updated to match the actual
> > patch.
> >
> Yes, I need to update the commit message as the content of the patch
> changed a bit.
>
> > > changes the link training does no longer apply the
> > > previously computed voltage swing and pre-emphasis values.
> > > Instead, the link training is started with zero values.
> > >
> > > v4: Parameter and debug message naming improvements.
> > > Fix for link parameter check (Ville)
> > >
> > > v3: Remove cached old link parameters. Instead, disable
> > > fast link training feature when link parameters are
> > > set (Ville)
> > >
> > > v2: Readout DPCD register to check if no aux handshaking is
> > > required in link training (Ander)
> > >
> > > Signed-off-by: Mika Kahola <mika.kahola at intel.com>
> > > ---
> > > drivers/gpu/drm/i915/intel_dp.c | 8 +++++++-
> > > drivers/gpu/drm/i915/intel_dp_link_training.c | 17 +++++++++++++++++
> > > drivers/gpu/drm/i915/intel_drv.h | 1 +
> > > 3 files changed, 25 insertions(+), 1 deletion(-)
> > >
> > > diff --git a/drivers/gpu/drm/i915/intel_dp.c b/drivers/gpu/drm/i915/intel_dp.c
> > > index 31ba241..82504f0 100644
> > > --- a/drivers/gpu/drm/i915/intel_dp.c
> > > +++ b/drivers/gpu/drm/i915/intel_dp.c
> > > @@ -1677,6 +1677,12 @@ found:
> > > void intel_dp_set_link_params(struct intel_dp *intel_dp,
> > > const struct intel_crtc_state *pipe_config)
> > > {
> > > + if (intel_dp->link_rate != pipe_config->port_clock ||
> > > + intel_dp->lane_count != pipe_config->lane_count) {
> > > + intel_dp->train_set_valid = false;
> > > + DRM_DEBUG_KMS("setting train set valid as false\n");
> >
> > Maybe "Link parameters changed, resetting vswing and pre-emphasis" ?
> >
> > Also maybe check for train_set_valid being true as well so that we
> > don't print the debug message unless we're really resetting the flag.
> >
> Actually, I forgot to clean up this debug message. This was only
> intended for my personal use when I did the testing. I'll remove this
> debug message. Very good catch!
>
> > > + }
> > > +
> > > intel_dp->link_rate = pipe_config->port_clock;
> > > intel_dp->lane_count = pipe_config->lane_count;
> > > }
> > > @@ -3849,7 +3855,7 @@ intel_dp_link_down(struct intel_dp *intel_dp)
> > > intel_dp->DP = DP;
> > > }
> > >
> > > -static bool
> > > +bool
> > > intel_dp_get_dpcd(struct intel_dp *intel_dp)
> > > {
> > > struct intel_digital_port *dig_port = dp_to_dig_port(intel_dp);
> > > diff --git a/drivers/gpu/drm/i915/intel_dp_link_training.c b/drivers/gpu/drm/i915/intel_dp_link_training.c
> > > index 8888793..e46bad6 100644
> > > --- a/drivers/gpu/drm/i915/intel_dp_link_training.c
> > > +++ b/drivers/gpu/drm/i915/intel_dp_link_training.c
> > > @@ -85,6 +85,23 @@ static bool
> > > intel_dp_reset_link_train(struct intel_dp *intel_dp,
> > > uint8_t dp_train_pat)
> > > {
> > > + bool has_dpcd;
> > > + bool no_aux_handshake = false;
> > > +
> > > + has_dpcd = intel_dp_get_dpcd(intel_dp);
> > > +
> > > + if (has_dpcd) {
> > > + if (intel_dp->dpcd[DP_DPCD_REV] >= 0x11) {
> > > + no_aux_handshake = (intel_dp->dpcd[DP_MAX_DOWNSPREAD] &
> > > + DP_NO_AUX_HANDSHAKE_LINK_TRAINING);
> > > + }
> > > + }
> > > +
> > > + intel_dp->train_set_valid &= no_aux_handshake;
> >
> > This should be separate patch. And I'm not convinced it's correct
> > anyway. At least it's not anything mandated by the spec AFAICS, so
> > there should be a comment why we're doing it. Also there's no
> > mention of this change in the commit message either.
> >
> I could split this patch in two parts and leave this part as a follow
> up.
>
> The spec says
>
> "When DP Source device is resuming the transmission (e.g., after waking
> from sleep), the Source device may skip the AUX transactions for the
> link training if the following conditions are met:
>
> - The Source device has determined that the HPD signal has remained
> asserted continuously (apart from IRQ_HPD notifications) since the link
> was last in full operation.
> - The Source device has read 1 in NO_AUX_TRANSACTION_LINK_TRAINING bit
> after the initial Sink device detection"
>
> My interpretation of the spec is that we would need to check this bit
> just to ensure that we are capable of doing link training without AUX
> transactions. Without this check the we are probably too optimistic of
> training the link by reusing the known good drive current and
> pre-emphasis level.
Starting a full training cycle with non-zero is mentioned as something
that is allowed in another part of the spec. To me it would make sense
to attempt it in any case. And then someone should perhaps implement
the real fast link training support for sinks that support it.
Though I still think we need
http://lists.freedesktop.org/archives/intel-gfx/2015-October/079195.html
since the current aux retry limits aren't high enough to make that
dongle happy otherwise.
>
> BTW, should we change the naming of the define
> "DP_NO_AUX_HANDSHAKE_LINK_TRAINING" as the spec discusses of
> "DP_NO_AUX_TRANSACTION_LINK_TRAINING"?
>
> > > +
> > > + DRM_DEBUG_KMS("link training optimization: %s\n",
> > > + intel_dp->train_set_valid ? "true" : "false");
> > > +
> > > if (!intel_dp->train_set_valid)
> > > memset(intel_dp->train_set, 0, sizeof(intel_dp->train_set));
> > > intel_dp_set_signal_levels(intel_dp);
> > > diff --git a/drivers/gpu/drm/i915/intel_drv.h b/drivers/gpu/drm/i915/intel_drv.h
> > > index 798463e..94041fd 100644
> > > --- a/drivers/gpu/drm/i915/intel_drv.h
> > > +++ b/drivers/gpu/drm/i915/intel_drv.h
> > > @@ -1239,6 +1239,7 @@ int intel_dp_sink_crc(struct intel_dp *intel_dp, u8 *crc);
> > > bool intel_dp_compute_config(struct intel_encoder *encoder,
> > > struct intel_crtc_state *pipe_config);
> > > bool intel_dp_is_edp(struct drm_device *dev, enum port port);
> > > +bool intel_dp_get_dpcd(struct intel_dp *intel_dp);
> > > enum irqreturn intel_dp_hpd_pulse(struct intel_digital_port *intel_dig_port,
> > > bool long_hpd);
> > > void intel_edp_backlight_on(struct intel_dp *intel_dp);
> > > --
> > > 1.9.1
> > >
> > > _______________________________________________
> > > Intel-gfx mailing list
> > > Intel-gfx at lists.freedesktop.org
> > > http://lists.freedesktop.org/mailman/listinfo/intel-gfx
> >
>
--
Ville Syrjälä
Intel OTC
More information about the Intel-gfx
mailing list