[Intel-gfx] [PATCH] drm/i915: Add debugfs entry for DRRS
Daniel Vetter
daniel at ffwll.ch
Mon Feb 23 16:39:08 PST 2015
On Mon, Feb 23, 2015 at 05:35:54PM +0530, Ramalingam C wrote:
> From: Vandana Kannan <vandana.kannan at intel.com>
>
> Adding a debugfs entry to determine if DRRS is supported or not
>
> V2: [By Ram]: Following details about the active crtc will be filled
> in seq-file of the debugfs
> 1. Encoder output type
> 2. DRRS Support on this CRTC
> 3. DRRS current state
> 4. Current Vrefresh
> Format is as follows:
> CRTC 1: Output: eDP, DRRS Supported: Yes (Seamless), DRRS_State: DRRS_HIGH_RR, Vrefresh: 60
> CRTC 2: Output: HDMI, DRRS Supported : No, VBT DRRS_type: Seamless
> CRTC 1: Output: eDP, DRRS Supported: Yes (Seamless), DRRS_State: DRRS_LOW_RR, Vrefresh: 40
> CRTC 2: Output: HDMI, DRRS Supported : No, VBT DRRS_type: Seamless
>
> V3: [By Ram]: Readability is improved.
> Another error case is covered [Daniel]
>
> V4: [By Ram]: Current status of the Idleness DRRS along with
> the Front buffer bits are added to the debugfs. [Rodrigo]
>
> V5: [By Ram]: Rephrased to make it easy to understand.
> And format is modified. [Rodrigo]
>
> Signed-off-by: Vandana Kannan <vandana.kannan at intel.com>
> Signed-off-by: Ramalingam C <ramalingam.c at intel.com>
Total absence of locking while walking modesetting structures is a bit
uncool.
> ---
> drivers/gpu/drm/i915/i915_debugfs.c | 113 +++++++++++++++++++++++++++++++++++
> 1 file changed, 113 insertions(+)
>
> diff --git a/drivers/gpu/drm/i915/i915_debugfs.c b/drivers/gpu/drm/i915/i915_debugfs.c
> index 164fa82..e51001c 100644
> --- a/drivers/gpu/drm/i915/i915_debugfs.c
> +++ b/drivers/gpu/drm/i915/i915_debugfs.c
> @@ -2869,6 +2869,118 @@ static int i915_ddb_info(struct seq_file *m, void *unused)
> return 0;
> }
>
> +static void drrs_status_per_crtc(struct seq_file *m,
> + struct drm_device *dev, struct intel_crtc *intel_crtc)
> +{
> + struct intel_encoder *intel_encoder;
> + struct drm_i915_private *dev_priv = dev->dev_private;
> + struct i915_drrs *drrs = &dev_priv->drrs;
> + int vrefresh = 0;
> + u32 work_status;
> +
> + for_each_encoder_on_crtc(dev, &intel_crtc->base, intel_encoder) {
> + /* Encoder connected on this CRTC */
> + switch (intel_encoder->type) {
> + case INTEL_OUTPUT_EDP:
> + seq_puts(m, "eDP:\n");
> + break;
> + case INTEL_OUTPUT_DSI:
> + seq_puts(m, "DSI:\n");
> + break;
> + case INTEL_OUTPUT_HDMI:
> + seq_puts(m, "HDMI:\n");
> + break;
> + case INTEL_OUTPUT_DISPLAYPORT:
> + seq_puts(m, "DP:\n");
> + break;
> + default:
> + seq_printf(m, "Other encoder (id=%d).\n",
> + intel_encoder->type);
> + return;
> + }
> + }
> +
> + if (dev_priv->vbt.drrs_type == STATIC_DRRS_SUPPORT)
> + seq_puts(m, "\tVBT: DRRS_type: Static");
> + else if (dev_priv->vbt.drrs_type == SEAMLESS_DRRS_SUPPORT)
> + seq_puts(m, "\tVBT: DRRS_type: Seamless");
> + else if (dev_priv->vbt.drrs_type == DRRS_NOT_SUPPORTED)
> + seq_puts(m, "\tVBT: DRRS_type: None");
> + else
> + seq_puts(m, "\tVBT: DRRS_type: FIXME: Unrecognized Value");
> +
> + seq_puts(m, "\n\n");
> +
> + if (intel_crtc->config->has_drrs) {
> + struct intel_panel *panel;
> +
> + panel = &drrs->dp->attached_connector->panel;
Same here, chasing drrs pointers without grabbing the right locks isn't
awesome either. I've merged all the other patches in this series to dinq.
-Daniel
> + /* DRRS Supported */
> + seq_puts(m, "\tDRRS Supported: Yes\n");
> + seq_printf(m, "\t\tBusy_frontbuffer_bits: 0x%X",
> + drrs->busy_frontbuffer_bits);
> +
> + seq_puts(m, "\n\t\t");
> + work_status = work_busy(&drrs->work.work);
> + if (drrs->busy_frontbuffer_bits) {
> + seq_puts(m, "Front buffer: Busy.\n");
> + seq_puts(m, "\t\tIdleness DRRS: Disabled");
> + } else {
> + seq_puts(m, "Front buffer: Idle");
> + seq_puts(m, "\n\t\t");
> + if (drrs->refresh_rate_type == DRRS_HIGH_RR) {
> + if (work_status)
> + seq_puts(m, "Idleness DRRS: Enabled");
> + else
> + seq_puts(m, "Idleness DRRS: Disabled");
> + } else if (drrs->refresh_rate_type == DRRS_LOW_RR) {
> + seq_puts(m, "Idleness DRRS: Enabled");
> + }
> + }
> +
> + seq_puts(m, "\n\t\t");
> + if (drrs->refresh_rate_type == DRRS_HIGH_RR) {
> + seq_puts(m, "DRRS_State: DRRS_HIGH_RR\n");
> + vrefresh = panel->fixed_mode->vrefresh;
> + } else if (drrs->refresh_rate_type == DRRS_LOW_RR) {
> + seq_puts(m, "DRRS_State: DRRS_LOW_RR\n");
> + vrefresh = panel->downclock_mode->vrefresh;
> + } else {
> + seq_printf(m, "DRRS_State: Unknown(%d)\n",
> + drrs->refresh_rate_type);
> + return;
> + }
> + seq_printf(m, "\t\tVrefresh: %d", vrefresh);
> +
> + } else {
> + /* DRRS not supported. Print the VBT parameter*/
> + seq_puts(m, "\tDRRS Supported : No");
> + }
> + seq_puts(m, "\n");
> +}
> +
> +static int i915_drrs_status(struct seq_file *m, void *unused)
> +{
> + struct drm_info_node *node = m->private;
> + struct drm_device *dev = node->minor->dev;
> + struct intel_crtc *intel_crtc;
> + int active_crtc_cnt = 0;
> +
> + for_each_intel_crtc(dev, intel_crtc) {
> + if (intel_crtc->active) {
> + active_crtc_cnt++;
> + seq_printf(m, "\nCRTC %d: ", active_crtc_cnt);
> +
> + drrs_status_per_crtc(m, dev, intel_crtc);
> + }
> + }
> +
> + if (!active_crtc_cnt)
> + seq_puts(m, "No active crtc found\n");
> +
> + return 0;
> +}
> +
> struct pipe_crc_info {
> const char *name;
> struct drm_device *dev;
> @@ -4483,6 +4595,7 @@ static const struct drm_info_list i915_debugfs_list[] = {
> {"i915_dp_mst_info", i915_dp_mst_info, 0},
> {"i915_wa_registers", i915_wa_registers, 0},
> {"i915_ddb_info", i915_ddb_info, 0},
> + {"i915_drrs_status", i915_drrs_status, 0},
> };
> #define I915_DEBUGFS_ENTRIES ARRAY_SIZE(i915_debugfs_list)
>
> --
> 1.7.9.5
>
> _______________________________________________
> Intel-gfx mailing list
> Intel-gfx at lists.freedesktop.org
> http://lists.freedesktop.org/mailman/listinfo/intel-gfx
--
Daniel Vetter
Software Engineer, Intel Corporation
+41 (0) 79 365 57 48 - http://blog.ffwll.ch
More information about the Intel-gfx
mailing list