[Intel-gfx] [PATCH 06/18] drm/i915: Fill in more crtc state.

[Maarten Lankhorst]

Perform a full readout of the state by making sure the mode is set
up correctly atomically.

Also there was a small memory leak by doing the memset, fix this
by calling __drm_atomic_helper_crtc_destroy_state first.

Signed-off-by: Maarten Lankhorst <maarten.lankhorst at linux.intel.com>
---
 drivers/gpu/drm/i915/intel_display.c | 39 ++++++++++++++++--------------------
 drivers/gpu/drm/i915/intel_fbdev.c   |  9 ++-------
 2 files changed, 19 insertions(+), 29 deletions(-)

diff --git a/drivers/gpu/drm/i915/intel_display.c b/drivers/gpu/drm/i915/intel_display.c
index a3f9080828bd..34d756250c76 100644
--- a/drivers/gpu/drm/i915/intel_display.c
+++ b/drivers/gpu/drm/i915/intel_display.c
@@ -15229,6 +15229,7 @@ static void intel_sanitize_crtc(struct intel_crtc *crtc)
 {
 	struct drm_device *dev = crtc->base.dev;
 	struct drm_i915_private *dev_priv = dev->dev_private;
+	struct intel_crtc_state *pipe_config = to_intel_crtc_state(crtc->base.state);
 	struct intel_encoder *encoder;
 	u32 reg;
 	bool enable;
@@ -15237,9 +15238,20 @@ static void intel_sanitize_crtc(struct intel_crtc *crtc)
 	reg = PIPECONF(crtc->config->cpu_transcoder);
 	I915_WRITE(reg, I915_READ(reg) & ~PIPECONF_FRAME_START_DELAY_MASK);
 
+	memset(&crtc->base.mode, 0, sizeof(crtc->base.mode));
+	if (pipe_config->base.active) {
+		intel_mode_from_pipe_config(&crtc->base.mode, pipe_config);
+		intel_mode_from_pipe_config(&pipe_config->base.adjusted_mode, pipe_config);
+		crtc->base.hwmode = pipe_config->base.adjusted_mode;
+
+		WARN_ON(drm_atomic_set_mode_for_crtc(&pipe_config->base, &crtc->base.mode) < 0);
+	} else
+		WARN_ON(drm_atomic_set_mode_for_crtc(&pipe_config->base, NULL) < 0);
+
 	/* restore vblank interrupts to correct state */
 	drm_crtc_vblank_reset(&crtc->base);
 	if (crtc->active) {
+		drm_calc_timestamping_constants(&crtc->base, &crtc->base.hwmode);
 		update_scanline_offset(crtc);
 		drm_crtc_vblank_on(&crtc->base);
 	}
@@ -15292,9 +15304,8 @@ static void intel_sanitize_crtc(struct intel_crtc *crtc)
 			      crtc->base.state->enable ? "enabled" : "disabled",
 			      crtc->active ? "enabled" : "disabled");
 
-		crtc->base.state->enable = crtc->active;
-		crtc->base.state->active = crtc->active;
-		crtc->base.enabled = crtc->active;
+		crtc->base.enabled = crtc->base.state->active = crtc->active;
+		WARN_ON(drm_atomic_set_mode_for_crtc(&pipe_config->base, NULL) < 0);
 
 		/* Because we only establish the connector -> encoder ->
 		 * crtc links if something is active, this means the
@@ -15467,6 +15478,7 @@ static void intel_modeset_readout_hw_state(struct drm_device *dev)
 	int i;
 
 	for_each_intel_crtc(dev, crtc) {
+		__drm_atomic_helper_crtc_destroy_state(&crtc->base, crtc->base.state);
 		memset(crtc->config, 0, sizeof(*crtc->config));
 		crtc->config->base.crtc = &crtc->base;
 
@@ -15475,10 +15487,8 @@ static void intel_modeset_readout_hw_state(struct drm_device *dev)
 		crtc->active = dev_priv->display.get_pipe_config(crtc,
 								 crtc->config);
 
-		crtc->base.state->enable = crtc->active;
-		crtc->base.state->active = crtc->active;
-		crtc->base.enabled = crtc->active;
-		crtc->base.hwmode = crtc->config->base.adjusted_mode;
+		crtc->base.enabled = crtc->base.state->active = crtc->active;
+		WARN_ON(drm_atomic_set_mode_for_crtc(crtc->base.state, NULL) < 0);
 
 		readout_plane_state(crtc, to_intel_crtc_state(crtc->base.state));
 
@@ -15556,21 +15566,6 @@ void intel_modeset_setup_hw_state(struct drm_device *dev,
 
 	intel_modeset_readout_hw_state(dev);
 
-	/*
-	 * Now that we have the config, copy it to each CRTC struct
-	 * Note that this could go away if we move to using crtc_config
-	 * checking everywhere.
-	 */
-	for_each_intel_crtc(dev, crtc) {
-		if (crtc->active && i915.fastboot) {
-			intel_mode_from_pipe_config(&crtc->base.mode,
-						    crtc->config);
-			DRM_DEBUG_KMS("[CRTC:%d] found active mode: ",
-				      crtc->base.base.id);
-			drm_mode_debug_printmodeline(&crtc->base.mode);
-		}
-	}
-
 	/* HW state is read out, now we need to sanitize this mess. */
 	for_each_intel_encoder(dev, encoder) {
 		intel_sanitize_encoder(encoder);
diff --git a/drivers/gpu/drm/i915/intel_fbdev.c b/drivers/gpu/drm/i915/intel_fbdev.c
index 3d5bb56477ab..52d20cea182c 100644
--- a/drivers/gpu/drm/i915/intel_fbdev.c
+++ b/drivers/gpu/drm/i915/intel_fbdev.c
@@ -486,16 +486,11 @@ retry:
 			 * config, not the input mode, which is what crtc->mode
 			 * usually contains. But since our current fastboot
 			 * code puts a mode derived from the post-pfit timings
-			 * into crtc->mode this works out correctly. We don't
-			 * use hwmode anywhere right now, so use it for this
-			 * since the fb helper layer wants a pointer to
-			 * something we own.
+			 * into crtc->mode this works out correctly.
 			 */
 			DRM_DEBUG_KMS("looking for current mode on connector %s\n",
 				      connector->name);
-			intel_mode_from_pipe_config(&encoder->crtc->hwmode,
-						    to_intel_crtc(encoder->crtc)->config);
-			modes[i] = &encoder->crtc->hwmode;
+			modes[i] = &encoder->crtc->mode;
 		}
 		crtcs[i] = new_crtc;
 
-- 
2.1.0