[Intel-gfx] [PATCH 12/15] drm/i915: Interrupt routing for GuC submission
Dave Gordon
david.s.gordon at intel.com
Mon Jun 15 11:36:30 PDT 2015
Turn on interrupt steering to route necessary interrupts to GuC.
Issue: VIZ-4884
Signed-off-by: Alex Dai <yu.dai at intel.com>
Signed-off-by: Dave Gordon <david.s.gordon at intel.com>
---
drivers/gpu/drm/i915/i915_reg.h | 11 +++++--
drivers/gpu/drm/i915/intel_guc_loader.c | 51 +++++++++++++++++++++++++++++++
2 files changed, 60 insertions(+), 2 deletions(-)
diff --git a/drivers/gpu/drm/i915/i915_reg.h b/drivers/gpu/drm/i915/i915_reg.h
index 56f81de..e255253 100644
--- a/drivers/gpu/drm/i915/i915_reg.h
+++ b/drivers/gpu/drm/i915/i915_reg.h
@@ -1638,12 +1638,18 @@ enum skl_disp_power_wells {
#define GFX_MODE_GEN7 0x0229c
#define RING_MODE_GEN7(ring) ((ring)->mmio_base+0x29c)
#define GFX_RUN_LIST_ENABLE (1<<15)
+#define GFX_INTERRUPT_STEERING (1<<14)
#define GFX_TLB_INVALIDATE_EXPLICIT (1<<13)
#define GFX_SURFACE_FAULT_ENABLE (1<<12)
#define GFX_REPLAY_MODE (1<<11)
#define GFX_PSMI_GRANULARITY (1<<10)
#define GFX_PPGTT_ENABLE (1<<9)
+#define GFX_FORWARD_VBLANK_MASK (3<<5)
+#define GFX_FORWARD_VBLANK_NEVER (0<<5)
+#define GFX_FORWARD_VBLANK_ALWAYS (1<<5)
+#define GFX_FORWARD_VBLANK_COND (2<<5)
+
#define VLV_DISPLAY_BASE 0x180000
#define VLV_MIPI_BASE VLV_DISPLAY_BASE
@@ -5627,11 +5633,12 @@ enum skl_disp_power_wells {
#define GEN8_GT_IIR(which) (0x44308 + (0x10 * (which)))
#define GEN8_GT_IER(which) (0x4430c + (0x10 * (which)))
-#define GEN8_BCS_IRQ_SHIFT 16
#define GEN8_RCS_IRQ_SHIFT 0
-#define GEN8_VCS2_IRQ_SHIFT 16
+#define GEN8_BCS_IRQ_SHIFT 16
#define GEN8_VCS1_IRQ_SHIFT 0
+#define GEN8_VCS2_IRQ_SHIFT 16
#define GEN8_VECS_IRQ_SHIFT 0
+#define GEN8_WD_IRQ_SHIFT 16
#define GEN8_DE_PIPE_ISR(pipe) (0x44400 + (0x10 * (pipe)))
#define GEN8_DE_PIPE_IMR(pipe) (0x44404 + (0x10 * (pipe)))
diff --git a/drivers/gpu/drm/i915/intel_guc_loader.c b/drivers/gpu/drm/i915/intel_guc_loader.c
index 6e4667d..204777b 100644
--- a/drivers/gpu/drm/i915/intel_guc_loader.c
+++ b/drivers/gpu/drm/i915/intel_guc_loader.c
@@ -62,6 +62,53 @@
#define I915_SKL_GUC_UCODE "i915/skl_guc_ver3.bin"
MODULE_FIRMWARE(I915_SKL_GUC_UCODE);
+static void direct_interrupts_to_host(struct drm_i915_private *dev_priv)
+{
+ struct intel_engine_cs *ring;
+ int i, irqs;
+
+ /* tell all command streamers NOT to forward interrupts and vblank to GuC */
+ irqs = _MASKED_FIELD(GFX_FORWARD_VBLANK_MASK, GFX_FORWARD_VBLANK_NEVER);
+ irqs |= _MASKED_BIT_DISABLE(GFX_INTERRUPT_STEERING);
+ for_each_ring(ring, dev_priv, i)
+ I915_WRITE(RING_MODE_GEN7(ring), irqs);
+
+ /* tell DE to send nothing to GuC */
+ I915_WRITE(DE_GUCRMR, ~0);
+
+ /* route all GT interrupts to the host */
+ I915_WRITE(GUC_BCS_RCS_IER, 0);
+ I915_WRITE(GUC_VCS2_VCS1_IER, 0);
+ I915_WRITE(GUC_WD_VECS_IER, 0);
+}
+
+static void direct_interrupts_to_guc(struct drm_i915_private *dev_priv)
+{
+ struct intel_engine_cs *ring;
+ int i, irqs;
+
+ /* tell all command streamers to forward interrupts and vblank to GuC */
+ irqs = _MASKED_FIELD(GFX_FORWARD_VBLANK_MASK, GFX_FORWARD_VBLANK_ALWAYS);
+ irqs |= _MASKED_BIT_ENABLE(GFX_INTERRUPT_STEERING);
+ for_each_ring(ring, dev_priv, i)
+ I915_WRITE(RING_MODE_GEN7(ring), irqs);
+
+ /* tell DE to send (all) flip_done to GuC */
+ irqs = DERRMR_PIPEA_PRI_FLIP_DONE | DERRMR_PIPEA_SPR_FLIP_DONE |
+ DERRMR_PIPEB_PRI_FLIP_DONE | DERRMR_PIPEB_SPR_FLIP_DONE |
+ DERRMR_PIPEC_PRI_FLIP_DONE | DERRMR_PIPEC_SPR_FLIP_DONE;
+ /* Unmasked bits will cause GuC response message to be sent */
+ I915_WRITE(DE_GUCRMR, ~irqs);
+
+ /* route USER_INTERRUPT to Host, all others are sent to GuC. */
+ irqs = GT_RENDER_USER_INTERRUPT << GEN8_RCS_IRQ_SHIFT |
+ GT_RENDER_USER_INTERRUPT << GEN8_BCS_IRQ_SHIFT;
+ /* These three registers have the same bit definitions */
+ I915_WRITE(GUC_BCS_RCS_IER, ~irqs);
+ I915_WRITE(GUC_VCS2_VCS1_IER, ~irqs);
+ I915_WRITE(GUC_WD_VECS_IER, ~irqs);
+}
+
static u32 get_gttype(struct drm_device *dev)
{
/* XXX: GT type based on PCI device ID? field seems unused by fw */
@@ -390,6 +437,7 @@ int intel_guc_ucode_load(struct drm_device *dev, bool wait)
if (guc_fw->uc_fw_fetch_status == INTEL_UC_FIRMWARE_PENDING && !wait)
return -EAGAIN;
+ direct_interrupts_to_host(dev_priv);
i915_guc_submission_disable(dev);
if (guc_fw->uc_fw_fetch_status == INTEL_UC_FIRMWARE_NONE)
@@ -418,6 +466,7 @@ int intel_guc_ucode_load(struct drm_device *dev, bool wait)
err = i915_guc_submission_enable(dev);
if (err)
goto fail;
+ direct_interrupts_to_guc(dev_priv);
}
return 0;
@@ -426,6 +475,7 @@ fail:
if (guc_fw->uc_fw_load_status == INTEL_UC_FIRMWARE_PENDING)
guc_fw->uc_fw_load_status = INTEL_UC_FIRMWARE_FAIL;
+ direct_interrupts_to_host(dev_priv);
i915_guc_submission_disable(dev);
DRM_ERROR("Failed to initialize GuC, error %d\n", err);
@@ -441,6 +491,7 @@ void intel_guc_ucode_fini(struct drm_device *dev)
struct drm_i915_private *dev_priv = dev->dev_private;
struct intel_uc_fw *guc_fw = &dev_priv->guc.guc_fw;
+ direct_interrupts_to_host(dev_priv);
i915_guc_submission_fini(dev);
intel_uc_fw_fini(guc_fw);
--
1.7.9.5
More information about the Intel-gfx
mailing list