[Intel-gfx] [RFC v5 1/9] drivers/mfd: Add lookup table for Panel Control as GPIO signal

[Linus Walleij]

On Thu, Mar 12, 2015 at 5:31 PM, Shobhit Kumar <shobhit.kumar at intel.com> wrote:

> On some Intel SoC platforms, the panel enable/disable signals are
> controlled by CRC PMIC. Add those control as a new GPIO in a lookup
> table for gpio-crystalcove chip during CRC driver load
>
> CC: Samuel Ortiz <sameo at linux.intel.com>
> Cc: Linus Walleij <linus.walleij at linaro.org>
> Cc: Alexandre Courbot <gnurou at gmail.com>
> Cc: Thierry Reding <thierry.reding at gmail.com>
> Signed-off-by: Shobhit Kumar <shobhit.kumar at intel.com>

So as I think it is better to use a fixed voltage regulator (see code
example in the i915 patch) I think this
should register a regulator lookup instead.

Yours,
Linus Walleij