[Intel-gfx] [PATCH 2/2] drm/i915/BXT: Tolerance at BXT DSI pipe_config comparison

[Ramalingam C]

On Wednesday 13 April 2016 08:16 PM, Daniel Vetter wrote:
> On Wed, Apr 13, 2016 at 06:34:25PM +0530, Ramalingam C wrote:
>> On Wednesday 13 April 2016 05:27 PM, Daniel Vetter wrote:
>>> On Wed, Apr 13, 2016 at 1:48 PM, Daniel Vetter <daniel at ffwll.ch> wrote:
>>>> On Wed, Apr 13, 2016 at 1:06 PM, Jani Nikula <jani.nikula at intel.com> wrote:
>>>>>> Then fix adjusted_mode to have the timings in terms of txbyteclkhs
>>>>>> already. Problem solved.
>>>>> I let Ville convince me there would be problems with that. Ville, care
>>>>> to fill in the details?
>>>> If we change them too hard the accurate vblank timestamp stuff will be
>>>> upset. But then we only need to adjust horizontal timings for dsi,
>>>> whereas on gen5+ the vblank ts code uses the line counter (i.e.
>>>> vertical timings) only.
>>>>
>>>> If it's just that it should work, and I don't think we have any other
>>>> users of the adjusted_mode.
>>> Ok, I was wrong and we obviously need the right dotclock to compute
>>> linedur_ns correctly in drm_calc_timestamping_constants(). So either
>>> we adjust the dotclock of adjusted_mode too (imo makes most sense), or
>>> we need yet another mode somewhere and use that for dsi cross checking
>>> (real ugly imo). More I missed?
>> Another point to be considered:
>> And we program hsync, hfp and hbp in terms of txbyteclkhs to port register,
>> which are not part of adjusted_mode.
>> So for BXT DSI, we have to store them interms of txbyteclkhs and compare
>> with hsync, hfp and hbp read from HW??
> Yeah that's my idea. Plus we should probably store txbyteclkhs somewhere,
> too. Or at least we need to adjust the clock in adjusted_mode to match
> txbyteclkhs, otherwise the vblank ts code goes off the rails.
Ok. I will post a RFC for this. But for that we need to finalize few points.

1. We need to add three more variables in pipe_config for caching(SW and 
HW State) the hfp, hsync and hbp.
2. On BXT DSI, We will compare the hdisplay, hfp, hsync and hbp only on 
pipe_config_compare not all horizontal timing param of adjusted mode.
3. So we dont need to recalculate all horizontal timing parameters of 
adjusted_mode from port register at get_config(). Should we fill them 
too (No harm Though)?

Please clarify if we are fine with above points.

-Ram
> -Daniel

-- 
Thanks,
--Ram