[Intel-gfx] [PATCH] drm/i915: Wait for power cycle delay after turning off DSI panel power

[Jani Nikula]

On Mon, 18 Apr 2016, ville.syrjala at linux.intel.com wrote:
> From: Ville Syrjälä <ville.syrjala at linux.intel.com>
>
> The power cycle delay starts _after_ turning off the panel power. Do the
> msleep after frobbing the pmic panel power gpio.
>
> Also toss in a FIXME about optimizing away needless waits.
>
> Cc: Shobhit Kumar <shobhit.kumar at intel.com>
> Cc: Jani Nikula <jani.nikula at intel.com>
> Fixes: fc45e8219907 ("drm/i915: Use the CRC gpio for panel enable/disable")
> Signed-off-by: Ville Syrjälä <ville.syrjala at linux.intel.com>

Reviewed-by: Jani Nikula <jani.nikula at intel.com>


> ---
>  drivers/gpu/drm/i915/intel_dsi.c | 7 ++++++-
>  1 file changed, 6 insertions(+), 1 deletion(-)
>
> diff --git a/drivers/gpu/drm/i915/intel_dsi.c b/drivers/gpu/drm/i915/intel_dsi.c
> index 34328ddaaab5..2b22bb9bb86f 100644
> --- a/drivers/gpu/drm/i915/intel_dsi.c
> +++ b/drivers/gpu/drm/i915/intel_dsi.c
> @@ -688,11 +688,16 @@ static void intel_dsi_post_disable(struct intel_encoder *encoder)
>  	drm_panel_unprepare(intel_dsi->panel);
>  
>  	msleep(intel_dsi->panel_off_delay);
> -	msleep(intel_dsi->panel_pwr_cycle_delay);
>  
>  	/* Panel Disable over CRC PMIC */
>  	if (intel_dsi->gpio_panel)
>  		gpiod_set_value_cansleep(intel_dsi->gpio_panel, 0);
> +
> +	/*
> +	 * FIXME As we do with eDP, just make a note of the time here
> +	 * and perform the wait before the next panel power on.
> +	 */
> +	msleep(intel_dsi->panel_pwr_cycle_delay);
>  }
>  
>  static bool intel_dsi_get_hw_state(struct intel_encoder *encoder,

-- 
Jani Nikula, Intel Open Source Technology Center