[Intel-gfx] [PATCH 03/12] drm/i915: Avoid mixing up SST and MST in DDI setup
Daniel Vetter
daniel at ffwll.ch
Tue Aug 2 14:20:18 UTC 2016
On Fri, Jul 29, 2016 at 12:55:20PM +0300, Ville Syrjälä wrote:
> On Fri, Jul 29, 2016 at 11:16:19AM +0200, Daniel Vetter wrote:
> > On Thu, Jul 28, 2016 at 05:50:39PM +0300, ville.syrjala at linux.intel.com wrote:
> > > From: Ville Syrjälä <ville.syrjala at linux.intel.com>
> > >
> > > The MST vs. SST selection should depend purely on the choice of the
> > > connector/encoder. So don't try to determine the correct DDI mode
> > > based on the intel_dp->is_mst, which simply tells us whether the sink
> > > is in MST mode or not. Instead derive the information from the encoder
> > > type. Since the link training code deals in non-fake encoders, we'll
> > > also need to keep a second copy of that information around, which we'll
> > > now designate as 'link_mst'.
> > >
> > > Cc: Maarten Lankhorst <maarten.lankhorst at linux.intel.com>
> > > Signed-off-by: Ville Syrjälä <ville.syrjala at linux.intel.com>
> >
> > Hm, I think it'd be nice if we could shovel all this stuff into the crtc
> > state I think, instead of noodling it out of somewhere else.
>
> You mean stuffing a pre-computed (partial?) register value in the
> crtc state? That could work too.
Yeah. But reading ahead I'm not sure where exactly we need to store that,
since recovering that with your sync_state rfc might get tricky.
-Daniel
>
> > But since we
> > always update it in pre_enable hooks it should be all fine even with
> > TEST_ONLY atomic.
> >
> > I digress, change looks good.
> >
> > Reviewed-by: Daniel Vetter <daniel.vetter at ffwll.ch>
> >
> > > ---
> > > drivers/gpu/drm/i915/intel_ddi.c | 21 +++------------------
> > > drivers/gpu/drm/i915/intel_dp.c | 1 +
> > > drivers/gpu/drm/i915/intel_drv.h | 1 +
> > > 3 files changed, 5 insertions(+), 18 deletions(-)
> > >
> > > diff --git a/drivers/gpu/drm/i915/intel_ddi.c b/drivers/gpu/drm/i915/intel_ddi.c
> > > index dd1d6fe12297..3b3a0a808477 100644
> > > --- a/drivers/gpu/drm/i915/intel_ddi.c
> > > +++ b/drivers/gpu/drm/i915/intel_ddi.c
> > > @@ -1111,7 +1111,6 @@ void intel_ddi_enable_transcoder_func(struct drm_crtc *crtc)
> > > {
> > > struct intel_crtc *intel_crtc = to_intel_crtc(crtc);
> > > struct intel_encoder *intel_encoder = intel_ddi_get_crtc_encoder(crtc);
> > > - struct drm_encoder *encoder = &intel_encoder->base;
> > > struct drm_device *dev = crtc->dev;
> > > struct drm_i915_private *dev_priv = to_i915(dev);
> > > enum pipe pipe = intel_crtc->pipe;
> > > @@ -1177,29 +1176,15 @@ void intel_ddi_enable_transcoder_func(struct drm_crtc *crtc)
> > > temp |= TRANS_DDI_MODE_SELECT_HDMI;
> > > else
> > > temp |= TRANS_DDI_MODE_SELECT_DVI;
> > > -
> > > } else if (type == INTEL_OUTPUT_ANALOG) {
> > > temp |= TRANS_DDI_MODE_SELECT_FDI;
> > > temp |= (intel_crtc->config->fdi_lanes - 1) << 1;
> > > -
> > > } else if (type == INTEL_OUTPUT_DP ||
> > > type == INTEL_OUTPUT_EDP) {
> > > - struct intel_dp *intel_dp = enc_to_intel_dp(encoder);
> > > -
> > > - if (intel_dp->is_mst) {
> > > - temp |= TRANS_DDI_MODE_SELECT_DP_MST;
> > > - } else
> > > - temp |= TRANS_DDI_MODE_SELECT_DP_SST;
> > > -
> > > + temp |= TRANS_DDI_MODE_SELECT_DP_SST;
> > > temp |= DDI_PORT_WIDTH(intel_crtc->config->lane_count);
> > > } else if (type == INTEL_OUTPUT_DP_MST) {
> > > - struct intel_dp *intel_dp = &enc_to_mst(encoder)->primary->dp;
> > > -
> > > - if (intel_dp->is_mst) {
> > > - temp |= TRANS_DDI_MODE_SELECT_DP_MST;
> > > - } else
> > > - temp |= TRANS_DDI_MODE_SELECT_DP_SST;
> > > -
> > > + temp |= TRANS_DDI_MODE_SELECT_DP_MST;
> > > temp |= DDI_PORT_WIDTH(intel_crtc->config->lane_count);
> > > } else {
> > > WARN(1, "Invalid encoder type %d for pipe %c\n",
> > > @@ -2105,7 +2090,7 @@ void intel_ddi_prepare_link_retrain(struct intel_dp *intel_dp)
> > >
> > > val = DP_TP_CTL_ENABLE |
> > > DP_TP_CTL_LINK_TRAIN_PAT1 | DP_TP_CTL_SCRAMBLE_DISABLE;
> > > - if (intel_dp->is_mst)
> > > + if (intel_dp->link_mst)
> > > val |= DP_TP_CTL_MODE_MST;
> > > else {
> > > val |= DP_TP_CTL_MODE_SST;
> > > diff --git a/drivers/gpu/drm/i915/intel_dp.c b/drivers/gpu/drm/i915/intel_dp.c
> > > index 8c38e3483989..0096c651c21f 100644
> > > --- a/drivers/gpu/drm/i915/intel_dp.c
> > > +++ b/drivers/gpu/drm/i915/intel_dp.c
> > > @@ -1651,6 +1651,7 @@ void intel_dp_set_link_params(struct intel_dp *intel_dp,
> > > {
> > > intel_dp->link_rate = pipe_config->port_clock;
> > > intel_dp->lane_count = pipe_config->lane_count;
> > > + intel_dp->link_mst = intel_crtc_has_type(pipe_config, INTEL_OUTPUT_DP_MST);
> > > }
> > >
> > > static void intel_dp_prepare(struct intel_encoder *encoder)
> > > diff --git a/drivers/gpu/drm/i915/intel_drv.h b/drivers/gpu/drm/i915/intel_drv.h
> > > index e74d851868c5..70d7f33d6747 100644
> > > --- a/drivers/gpu/drm/i915/intel_drv.h
> > > +++ b/drivers/gpu/drm/i915/intel_drv.h
> > > @@ -852,6 +852,7 @@ struct intel_dp {
> > > int link_rate;
> > > uint8_t lane_count;
> > > uint8_t sink_count;
> > > + bool link_mst;
> > > bool has_audio;
> > > bool detect_done;
> > > enum hdmi_force_audio force_audio;
> > > --
> > > 2.7.4
> > >
> > > _______________________________________________
> > > Intel-gfx mailing list
> > > Intel-gfx at lists.freedesktop.org
> > > https://lists.freedesktop.org/mailman/listinfo/intel-gfx
> >
> > --
> > Daniel Vetter
> > Software Engineer, Intel Corporation
> > http://blog.ffwll.ch
>
> --
> Ville Syrjälä
> Intel OTC
--
Daniel Vetter
Software Engineer, Intel Corporation
http://blog.ffwll.ch
More information about the Intel-gfx
mailing list