[Intel-gfx] [PATCH 12/18] drm/i915/dsi: Group DPOunit clock gate workaround with PLL enable
Hans de Goede
hdegoede at redhat.com
Thu Dec 1 20:29:19 UTC 2016
Move the DPOunit clock gate workaround to directly after the PLL enable.
The exact location of the workaround does not matter and there are 2
reasons to group it with the PLL enable:
1) This moves it out of the middle of the init sequence from the spec,
making it easier to follow the init sequence / compare it to the spec
2) It is grouped with the pll disable call in intel_dsi_post_disable,
so for consistency it should be grouped with the pll enable in
intel_dsi_pre_enable
Signed-off-by: Hans de Goede <hdegoede at redhat.com>
---
drivers/gpu/drm/i915/intel_dsi.c | 16 ++++++++--------
1 file changed, 8 insertions(+), 8 deletions(-)
diff --git a/drivers/gpu/drm/i915/intel_dsi.c b/drivers/gpu/drm/i915/intel_dsi.c
index 8927c7a..9e3cf54 100644
--- a/drivers/gpu/drm/i915/intel_dsi.c
+++ b/drivers/gpu/drm/i915/intel_dsi.c
@@ -636,14 +636,6 @@ static void intel_dsi_pre_enable(struct intel_encoder *encoder,
intel_disable_dsi_pll(encoder);
intel_enable_dsi_pll(encoder, pipe_config);
- intel_dsi_prepare(encoder, pipe_config);
-
- /* Power on, try both CRC pmic gpio and VBT */
- if (intel_dsi->gpio_panel)
- gpiod_set_value_cansleep(intel_dsi->gpio_panel, 1);
- intel_dsi_exec_vbt_sequence(intel_dsi, MIPI_SEQ_POWER_ON);
- msleep(intel_dsi->panel_on_delay);
-
if (IS_VALLEYVIEW(dev_priv) || IS_CHERRYVIEW(dev_priv)) {
u32 val;
@@ -653,6 +645,14 @@ static void intel_dsi_pre_enable(struct intel_encoder *encoder,
I915_WRITE(DSPCLK_GATE_D, val);
}
+ intel_dsi_prepare(encoder, pipe_config);
+
+ /* Power on, try both CRC pmic gpio and VBT */
+ if (intel_dsi->gpio_panel)
+ gpiod_set_value_cansleep(intel_dsi->gpio_panel, 1);
+ intel_dsi_exec_vbt_sequence(intel_dsi, MIPI_SEQ_POWER_ON);
+ msleep(intel_dsi->panel_on_delay);
+
/* put device in ready state */
intel_dsi_device_ready(encoder);
--
2.9.3
More information about the Intel-gfx
mailing list