[Intel-gfx] [PATCH] drm/i915/perf: use DRM_DEBUG for userspace issues

Daniel Vetter daniel at ffwll.ch
Fri Dec 2 08:35:59 UTC 2016


On Thu, Dec 01, 2016 at 05:21:52PM +0000, Robert Bragg wrote:
> Avoid using DRM_ERROR for conditions userspace can trigger with a bad
> config when opening a stream or from not reading data in a timely
> fashion (whereby the OA buffer fills up). These conditions are tested
> by i-g-t which treats error messages as failures if using the test
> runner. This wasn't an issue while the i915-perf igt tests were being
> run in isolation.
> 
> One message relating to seeing a spurious zeroed report was changed to
> use DRM_NOTE instead of DRM_ERROR. Ideally this warning shouldn't be
> seen, but it's not a serious problem if it is. Considering that the
> tail margin mechanism is only a heuristic it's possible we might see
> this from time to time.
> 
> Signed-off-by: Robert Bragg <robert at sixbynine.org:
> Cc: Daniel Vetter <daniel.vetter at ffwll.ch>
> 
> fix i915_perf dbg messages
> ---
>  drivers/gpu/drm/i915/i915_perf.c | 42 ++++++++++++++++++++--------------------
>  1 file changed, 21 insertions(+), 21 deletions(-)
> 
> diff --git a/drivers/gpu/drm/i915/i915_perf.c b/drivers/gpu/drm/i915/i915_perf.c
> index 9551282..5705005 100644
> --- a/drivers/gpu/drm/i915/i915_perf.c
> +++ b/drivers/gpu/drm/i915/i915_perf.c
> @@ -474,7 +474,7 @@ static int gen7_append_oa_reports(struct i915_perf_stream *stream,
>  		 * copying it to userspace...
>  		 */
>  		if (report32[0] == 0) {
> -			DRM_ERROR("Skipping spurious, invalid OA report\n");
> +			DRM_NOTE("Skipping spurious, invalid OA report\n");
>  			continue;

The above looks like a genuine hw/kernel fail, which we shouldn't put
under the carpet. I'd leave it at DRM_ERROR - I can bikeshed that while
applying if you're ok. Otherwise lgtm, will apply as soon as we've
clarified that.
-Daniel

>  		}
>  
> @@ -551,7 +551,7 @@ static int gen7_oa_read(struct i915_perf_stream *stream,
>  		if (ret)
>  			return ret;
>  
> -		DRM_ERROR("OA buffer overflow: force restart\n");
> +		DRM_DEBUG("OA buffer overflow: force restart\n");
>  
>  		dev_priv->perf.oa.ops.oa_disable(dev_priv);
>  		dev_priv->perf.oa.ops.oa_enable(dev_priv);
> @@ -1000,17 +1000,17 @@ static int i915_oa_stream_init(struct i915_perf_stream *stream,
>  	 * IDs
>  	 */
>  	if (!dev_priv->perf.metrics_kobj) {
> -		DRM_ERROR("OA metrics weren't advertised via sysfs\n");
> +		DRM_DEBUG("OA metrics weren't advertised via sysfs\n");
>  		return -EINVAL;
>  	}
>  
>  	if (!(props->sample_flags & SAMPLE_OA_REPORT)) {
> -		DRM_ERROR("Only OA report sampling supported\n");
> +		DRM_DEBUG("Only OA report sampling supported\n");
>  		return -EINVAL;
>  	}
>  
>  	if (!dev_priv->perf.oa.ops.init_oa_buffer) {
> -		DRM_ERROR("OA unit not supported\n");
> +		DRM_DEBUG("OA unit not supported\n");
>  		return -ENODEV;
>  	}
>  
> @@ -1019,17 +1019,17 @@ static int i915_oa_stream_init(struct i915_perf_stream *stream,
>  	 * we currently only allow exclusive access
>  	 */
>  	if (dev_priv->perf.oa.exclusive_stream) {
> -		DRM_ERROR("OA unit already in use\n");
> +		DRM_DEBUG("OA unit already in use\n");
>  		return -EBUSY;
>  	}
>  
>  	if (!props->metrics_set) {
> -		DRM_ERROR("OA metric set not specified\n");
> +		DRM_DEBUG("OA metric set not specified\n");
>  		return -EINVAL;
>  	}
>  
>  	if (!props->oa_format) {
> -		DRM_ERROR("OA report format not specified\n");
> +		DRM_DEBUG("OA report format not specified\n");
>  		return -EINVAL;
>  	}
>  
> @@ -1384,7 +1384,7 @@ i915_perf_open_ioctl_locked(struct drm_i915_private *dev_priv,
>  		if (IS_ERR(specific_ctx)) {
>  			ret = PTR_ERR(specific_ctx);
>  			if (ret != -EINTR)
> -				DRM_ERROR("Failed to look up context with ID %u for opening perf stream\n",
> +				DRM_DEBUG("Failed to look up context with ID %u for opening perf stream\n",
>  					  ctx_handle);
>  			goto err;
>  		}
> @@ -1397,7 +1397,7 @@ i915_perf_open_ioctl_locked(struct drm_i915_private *dev_priv,
>  	 */
>  	if (!specific_ctx &&
>  	    i915_perf_stream_paranoid && !capable(CAP_SYS_ADMIN)) {
> -		DRM_ERROR("Insufficient privileges to open system-wide i915 perf stream\n");
> +		DRM_DEBUG("Insufficient privileges to open system-wide i915 perf stream\n");
>  		ret = -EACCES;
>  		goto err_ctx;
>  	}
> @@ -1476,7 +1476,7 @@ static int read_properties_unlocked(struct drm_i915_private *dev_priv,
>  	memset(props, 0, sizeof(struct perf_open_properties));
>  
>  	if (!n_props) {
> -		DRM_ERROR("No i915 perf properties given");
> +		DRM_DEBUG("No i915 perf properties given\n");
>  		return -EINVAL;
>  	}
>  
> @@ -1487,7 +1487,7 @@ static int read_properties_unlocked(struct drm_i915_private *dev_priv,
>  	 * from userspace.
>  	 */
>  	if (n_props >= DRM_I915_PERF_PROP_MAX) {
> -		DRM_ERROR("More i915 perf properties specified than exist");
> +		DRM_DEBUG("More i915 perf properties specified than exist\n");
>  		return -EINVAL;
>  	}
>  
> @@ -1515,26 +1515,26 @@ static int read_properties_unlocked(struct drm_i915_private *dev_priv,
>  		case DRM_I915_PERF_PROP_OA_METRICS_SET:
>  			if (value == 0 ||
>  			    value > dev_priv->perf.oa.n_builtin_sets) {
> -				DRM_ERROR("Unknown OA metric set ID");
> +				DRM_DEBUG("Unknown OA metric set ID\n");
>  				return -EINVAL;
>  			}
>  			props->metrics_set = value;
>  			break;
>  		case DRM_I915_PERF_PROP_OA_FORMAT:
>  			if (value == 0 || value >= I915_OA_FORMAT_MAX) {
> -				DRM_ERROR("Invalid OA report format\n");
> +				DRM_DEBUG("Invalid OA report format\n");
>  				return -EINVAL;
>  			}
>  			if (!dev_priv->perf.oa.oa_formats[value].size) {
> -				DRM_ERROR("Invalid OA report format\n");
> +				DRM_DEBUG("Invalid OA report format\n");
>  				return -EINVAL;
>  			}
>  			props->oa_format = value;
>  			break;
>  		case DRM_I915_PERF_PROP_OA_EXPONENT:
>  			if (value > OA_EXPONENT_MAX) {
> -				DRM_ERROR("OA timer exponent too high (> %u)\n",
> -					  OA_EXPONENT_MAX);
> +				DRM_DEBUG("OA timer exponent too high (> %u)\n",
> +					 OA_EXPONENT_MAX);
>  				return -EINVAL;
>  			}
>  
> @@ -1565,7 +1565,7 @@ static int read_properties_unlocked(struct drm_i915_private *dev_priv,
>  
>  			if (oa_freq_hz > i915_oa_max_sample_rate &&
>  			    !capable(CAP_SYS_ADMIN)) {
> -				DRM_ERROR("OA exponent would exceed the max sampling frequency (sysctl dev.i915.oa_max_sample_rate) %uHz without root privileges\n",
> +				DRM_DEBUG("OA exponent would exceed the max sampling frequency (sysctl dev.i915.oa_max_sample_rate) %uHz without root privileges\n",
>  					  i915_oa_max_sample_rate);
>  				return -EACCES;
>  			}
> @@ -1575,7 +1575,7 @@ static int read_properties_unlocked(struct drm_i915_private *dev_priv,
>  			break;
>  		default:
>  			MISSING_CASE(id);
> -			DRM_ERROR("Unknown i915 perf property ID");
> +			DRM_DEBUG("Unknown i915 perf property ID\n");
>  			return -EINVAL;
>  		}
>  
> @@ -1595,7 +1595,7 @@ int i915_perf_open_ioctl(struct drm_device *dev, void *data,
>  	int ret;
>  
>  	if (!dev_priv->perf.initialized) {
> -		DRM_ERROR("i915 perf interface not available for this system");
> +		DRM_DEBUG("i915 perf interface not available for this system\n");
>  		return -ENOTSUPP;
>  	}
>  
> @@ -1603,7 +1603,7 @@ int i915_perf_open_ioctl(struct drm_device *dev, void *data,
>  			   I915_PERF_FLAG_FD_NONBLOCK |
>  			   I915_PERF_FLAG_DISABLED;
>  	if (param->flags & ~known_open_flags) {
> -		DRM_ERROR("Unknown drm_i915_perf_open_param flag\n");
> +		DRM_DEBUG("Unknown drm_i915_perf_open_param flag\n");
>  		return -EINVAL;
>  	}
>  
> -- 
> 2.10.2
> 
> _______________________________________________
> Intel-gfx mailing list
> Intel-gfx at lists.freedesktop.org
> https://lists.freedesktop.org/mailman/listinfo/intel-gfx

-- 
Daniel Vetter
Software Engineer, Intel Corporation
http://blog.ffwll.ch


More information about the Intel-gfx mailing list