[Intel-gfx] [PATCH] drm/i915/BXT: Configure DSI after enabling DSI pll

[Thulasimani, Sivakumar]

just realized that intel_dsi_init is not called from setup outputs for 
BXT. is this expected ?
if so when is it expected to be added ?

Again, the current code in intel_setup_outputs calls intel_dsi_init from
vlv/chv section so please confirm if this is needed for all platforms
or just in BXT.

On 2/2/2016 11:21 PM, Ramalingam C wrote:
> We need to enable DSI PLL before configuring the DSI registers.
>
> Signed-off-by: Ramalingam C <ramalingam.c at intel.com>
> ---
>   drivers/gpu/drm/i915/intel_dsi.c |    2 +-
>   1 file changed, 1 insertion(+), 1 deletion(-)
>
> diff --git a/drivers/gpu/drm/i915/intel_dsi.c b/drivers/gpu/drm/i915/intel_dsi.c
> index 91cef35..378f879 100644
> --- a/drivers/gpu/drm/i915/intel_dsi.c
> +++ b/drivers/gpu/drm/i915/intel_dsi.c
> @@ -478,8 +478,8 @@ static void intel_dsi_pre_enable(struct intel_encoder *encoder)
>   
>   	DRM_DEBUG_KMS("\n");
>   
> -	intel_dsi_prepare(encoder);
>   	intel_enable_dsi_pll(encoder);
> +	intel_dsi_prepare(encoder);
>   
>   	/* Panel Enable over CRC PMIC */
>   	if (intel_dsi->gpio_panel)