[Intel-gfx] [PATCH 3/3] drm/i915/gen9: Drop invalid WARN() during data rate calculation

[Matt Roper]

It's possible to have a non-zero plane mask and still wind up with a
total data rate of zero.  There are two cases where this can happen:

 * planes are active (from the KMS point of view), but are
   all fully clipped (positioned offscreen)
 * the only active plane on a CRTC is the cursor (which is handled
   independently and not counted into the general data rate computations

These are both valid display setups (although unusual), so we need to
drop the WARN().

Signed-off-by: Matt Roper <matthew.d.roper at intel.com>
---
 drivers/gpu/drm/i915/intel_pm.c | 2 --
 1 file changed, 2 deletions(-)

diff --git a/drivers/gpu/drm/i915/intel_pm.c b/drivers/gpu/drm/i915/intel_pm.c
index ba08639..2bd089e 100644
--- a/drivers/gpu/drm/i915/intel_pm.c
+++ b/drivers/gpu/drm/i915/intel_pm.c
@@ -3107,8 +3107,6 @@ skl_get_total_relative_data_rate(struct intel_crtc_state *intel_cstate)
 		total_data_rate += intel_cstate->wm.skl.plane_y_data_rate[id];
 	}
 
-	WARN_ON(cstate->plane_mask && total_data_rate == 0);
-
 	return total_data_rate;
 }
 
-- 
2.1.4