[Intel-gfx] [PATCH RESEND 5/7] drm/i915/panel: setup pwm backlight based on connector type

[Jani Nikula]

Use the connector type instead of VBT directly to decide which backlight
mechanism to use on VLV/CHV. (Indirectly, this is the same thing, but
hides the VBT use.)

Signed-off-by: Jani Nikula <jani.nikula at intel.com>
---
 drivers/gpu/drm/i915/intel_panel.c | 2 +-
 1 file changed, 1 insertion(+), 1 deletion(-)

diff --git a/drivers/gpu/drm/i915/intel_panel.c b/drivers/gpu/drm/i915/intel_panel.c
index 0fe059bc7d80..8c8996fcbaf5 100644
--- a/drivers/gpu/drm/i915/intel_panel.c
+++ b/drivers/gpu/drm/i915/intel_panel.c
@@ -1743,7 +1743,7 @@ intel_panel_init_backlight_funcs(struct intel_panel *panel)
 		panel->backlight.get = pch_get_backlight;
 		panel->backlight.hz_to_pwm = pch_hz_to_pwm;
 	} else if (IS_VALLEYVIEW(dev_priv) || IS_CHERRYVIEW(dev_priv)) {
-		if (dev_priv->vbt.has_mipi) {
+		if (connector->base.connector_type == DRM_MODE_CONNECTOR_DSI) {
 			panel->backlight.setup = pwm_setup_backlight;
 			panel->backlight.enable = pwm_enable_backlight;
 			panel->backlight.disable = pwm_disable_backlight;
-- 
2.1.4